yes there is, it drives the alternator and the water pump from the crank shaft
30,000miles
I need diagram serpentine belt for 1984 Nissan 4,2 L Nissan pick up
To change the serpentine belt on a 1988 Fiero GT, first, disconnect the negative battery terminal for safety. Locate the tensioner pulley and use a wrench to relieve tension on the belt, allowing you to remove the old belt. Route the new belt according to the diagram typically found on the engine bay or in the owner's manual, ensuring it is properly seated on all pulleys. Finally, reapply tension using the tensioner, double-check the belt alignment, and reconnect the battery.
There are 2 belts on my 1984. Inside belt crank shaft to water pump to alternator, should be a 50". Outside belt crank shaft to A/C, should be a 40" belt.
No, an accessory belt is not considered a serpentine belt. However, a serpentine belt is considered a specific type of accessory belt.
The water pump is powered by either a drive belt or serpentine belt. Follow the belt and you will locate the pump.
Pontiac Fiero was created in 1984.
There is no fan belt on any year Fiero. Electric fan motor,
The serpentine belt would be the same as the accessory drive belt.
Serpentine Belt Diagram ML320
Serpentine belt, no. Timing belt, good chance yes.
If the alternator belt is the same belt as the other accessories, yes.