To change the serpentine belt on a 1988 Fiero GT, first, disconnect the negative battery terminal for safety. Locate the tensioner pulley and use a wrench to relieve tension on the belt, allowing you to remove the old belt. Route the new belt according to the diagram typically found on the engine bay or in the owner's manual, ensuring it is properly seated on all pulleys. Finally, reapply tension using the tensioner, double-check the belt alignment, and reconnect the battery.
30,000miles
Loosen the tensioner pulley on your 1988 Chevrolet Corsica. When the tensioner pulley is loose the serpentine belt will easily come off. Put the new serpentine belt on and tighten the tensioner pulley.
There is no timing belt on 2.5L Fieros, the cam is gear driven.
yes there is, it drives the alternator and the water pump from the crank shaft
How do you change a serpentine belt on 2006 Envoy
how do you change serpentine belt gm 3.4 2003 venture
How Do I change the serpentine belt on a 1989 Cadillac Eldorado ?
how do you change the serpentine belt on a 2005 kia sodna
how do you change the serpentine belt on a 2001 Rodeo
the 4g63t does not have a serpentine belt, it has drive beltS
You can change the serpentine belt by loosening the tensioner pulley. When the tensioner pulley is loose and the serpentine belt will become loose. Put the new serpentine belt on and tighten the tensioner pulley.
Serpentine brote change