yes
You need a special tool to remove the crankshaft pulley on a 2003 Dodge Stratus. The correct tool is OTC Tool No. 6075. If you don't want to buy one, you can rent one from an AutoZone store.
There is a crankshaft pulley, alternator pulley, power steering pump pulley, AC pulley, idler pulley, tensioner pulley, etc.
You have to purchase a special pulley puller from Dodge, other wise you will break the pulley when you try to pull it off.
The crankshaft pulley is the large pulley on the lower passenger side of the engine.
You need to remove the bolt, insert the special tool in the hole, and install a three jaw puller to pull the pulley off.
No
The crankshaft sensor on a 2006 Dodge Stratus is located on the bottom of the engine near the oil filter. It tells the vehicle's computer where the crankshaft is located at any given moment. On the v6 it is on the top of the bell housing.
The crankshaft position sensor is located at the lower left hand side of the crankshaft pulley. The crankshaft pulley is the large pulley located in the center lower portion of the front of the engine.
It's a dodge so yes it would tra-tu s tart
The crankshaft sensor on a 2005 Dodge Stratus 2. 4 Liter is located on the bottom of the engine, near the oil filter. It constantly monitors the rotation of the crankshaft and updates the vehicle's computer on its current state.
Look at the crankshaft pulley, it is right there.
It is mounted just above the crankshaft pulley on the front of the engine.It is mounted just above the crankshaft pulley on the front of the engine.