You have to purchase a special pulley puller from Dodge, other wise you will break the pulley when you try to pull it off.
The crankshaft pulley is the large pulley on the lower passenger side of the engine.
The crankshaft position sensor is located at the lower left hand side of the crankshaft pulley. The crankshaft pulley is the large pulley located in the center lower portion of the front of the engine.
yes
Look at the crankshaft pulley, it is right there.
It is mounted just above the crankshaft pulley on the front of the engine.It is mounted just above the crankshaft pulley on the front of the engine.
There is a crankshaft pulley, alternator pulley, power steering pump pulley, AC pulley, idler pulley, tensioner pulley, etc.
Front of engine, reads off a a tone wheel behind the crankshaft pulley.
The crankshaft is in the lower part of the block. The connecting rods, flywheel, and crank pulley all bolt to it.
it is a 1 1/4 ( hollywood)
You need a special tool to remove the crankshaft pulley on a 2003 Dodge Stratus. The correct tool is OTC Tool No. 6075. If you don't want to buy one, you can rent one from an AutoZone store.
There is one on each end of the crankshaft. The front main seal is at the pulley and, while the rear main is at the transmission end.
Front driver side of the crankshaft pulley.