answersLogoWhite

0


Best Answer

no there is no inertia switch. gmjim

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is there an inertia switch for the fuel pump on a 1987 Pontiac Trans Am?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much horsepower does a 455 in a1987 Pontiac trans am put out?

The 1987 Trans Am didn't have a 455


Did Pontiac make a Trans Am Grand Theft Auto in 1985?

The Trans Am GTA was not intruduced until 1987.


What is the bolt pattern for a 1987 Pontiac trans am?

all camaros and firebirds, are 5lug x 4.75


What is the difference between the 1986 Pontiac trans am and 1986 Pontiac Grand Theft Auto?

Nothing, the GTA didn't come out until 1987.


Where is the inertia switch located on a Full Size 1987 Ford Bronco with a 302 engine and automatic transmission?

driver side board about 8 inches above the dimmer switch


What does the inertia switch do in a 1987 Bronco 2?

An inertia switch is a safety device that opens the electric circuit so that no power goes to the electric fuel pump if the vehicle is "jarred " enough If you have a bad enough collision or maybe hit a really bad pothole etc. The inertia switch can be manually reset


Shifter knob removal 87 Pontiac trans am?

The 1987 Pontiac Trans Am shifter knob is held in place with a retaining clip below the shifter knob. Push the retaining clip together and the shifter knob will raise off.


Where is the inertia switch on a 1987 Ford Thunderbird?

Looke either in the rear driver's side trunk area or in one of the kick panels


What could cause the coolin fans not to work on a 1987 Pontiac trans am gta?

Bad fans or the sensors that tell the fan when to kick on are bad.


Where is the ignition module located on a 1987 Pontiac trans am?

Under the cap, inside the distributor, it is easy to change with the distributor off the car, a pain to get to with it on the car.


Where is the brake switch on a 1987 Pontiac Grand Am?

Under the dash, either on the brake pedal's arm itself, or to the support structure.


Is there more than one reset for the fuel pump on a 1987 Ford Ranger 2.9L V6?

Nope. It's just the one inertia switch.