* A heat riser valve
To change PVC valve on a 1993 Nissan 300zx, first remove the oil dip stick and remove the tension clip from the PVC valve hose. Then remove the hose and the old PVC valve. Replace with a new PVC valve.
It is at the top of the valve cover. Hope that heps!
In the valve body of the transmission.
the right AV valve
It is very important to change PCV valve. If valve is old it will plug or seize. This will cause oil pressure to rise and may cause leaks. Most likely the valve cover gaskets will leak if PCV valve is plugged.
The bleeder valve for fuel injection for 1986 Nissan 300ZX is located at the furthest end of the fuel rail.
To change PVC valve on a 1993 Nissan 300zx, first remove the oil dip stick and remove the tension clip from the PVC valve hose. Then remove the hose and the old PVC valve. Replace with a new PVC valve.
check your idle control valve located behind the engine
Go to www.CarGrus.com and download you a repair manual. Your question would require extensive knowledge and multi pages of an answer.
Very back of the upper plenum on the driver side. It has a hose going to it from the center of the balance tube.
By selling it, because you obviously do not deserve to be a z32 owner if you can't complete a simple task like that. And no, an atmospheric blow off valve won't make you fast.
See the Chilton's manual for lies. Well, not lies, but only the passenger side, which is easy. Now if someone has something on the driver side....
Pcv valve is on the bottom sides of the intake plenum. Look under it by both strut tower locations and you should see two lower hoses that run right thru it. It screws right under the plenum...
Behind the plentum in the back of hte motor next to the firewall dead center. It looks like a pod with two pipes going in two differnet directions.
clearances valve nissan rd8
valve clearance Nissan d 27
valve clearance nissan d 27