0
Is there more than one coolant temp sensor on a 2000 intrigue?
Wiki User
∙ 15y ago
No
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Location of coolant temperature sensor on a 2003 Mercury Grand Marquis?
Location of coolant temperature sensor on a 2003 Mercury Grand Marquis?Read more: Location_of_coolant_temperature_sensor_on_a_2003_Mercury_Grand_Marquis
How do you reset the low coolant light on a 2000 Oldsmobile Intrigue?
There is no reset button or wsitch Check overflow tank under the hood and if low add coolant. If the coolant level is ok it may be the sensor on the bottom of tank is dirty with sluge. This sensor is the one which gives the low coolant indication. Remove tank and flush it out several times with clean water and re-install, refill tank with coolant to proper level.AnswerIt should go off when you fill up the coolant. If not, you may have a bad sensor, or possibly need to have it reset. Autozone can reset the diagnostic controller (DBM-II) for free while you wait. Hopefully there is no bigger problem that that. Answera. add more coolant b. if the light remains on, check the low coolant sensor and the connector that goes to it. It's usually on the side of the radiator or the bottom of the overflow tank.AnswerNo, there isn't a "reset" function for the low coolant level. The sensor (acts as a switch) will shut off the low coolant level warning light on the instrument cluster once you've filled up the coolant reservoir to the proper level. The coolant level sensor for this vehicle is located in the coolant reservoir (NOT THE RADIATOR). Keep in mind however, these sensors do go bad. So, just swap out the sensor? Not on this vehicle; the sensor isn't sold a a separate unit (darn it). You must purchase a new coolant reservoir, which includes a built in sensor. Multiple internet suppliers sell these reservoirs for $70 (including shipping).A correction to someone else's post: no, a diagnostic scanner (OBD-II) will not "reset" this warning light. So don't impose on Auto Zone on this one.
What is wrong if the cooling fan comes on when the coolant sensor is unplugged but when it is plugged in the fan and AC will not work?
I have seen this before more than likely your coolant sensor has a internal short and needs to be replaced.
Would a coolant sensor cause a rough idle?
Coolant sensors can cause a lot of various problems. The ECM relies on the coolant sensor for temperature readings. This is so that it can adjust the timing, fuel, and other related systems. But without knowing more I couldn't say that it is your problem.
Where is the radiator sensor located?
For the coolant level it is usually located in the coolant reservoir. For the coolant temperature it is usually located on the engine close to the thermostat or on a cylinder head. Need more info like year, make and model to help you more.
Is there more then 1 CKP sensor on a 2000 Mercury Villager?
No, there is not.
What is the function of the Coolant Temperature Sensor in a vw golf?
The coolant temperature sensor checks the coolant to let you know if overheating occurs. It also can send signals to the computer system to adjust the engine settings such as air/fuel mixture as needed to be more efficient based on engine temperature.
Where is the coolant temperature sensor on 99 Mercury Villager?
This is located right behind the coolant. It helps you to determine if the car is staying cool enough or if you need more liquids.
Why doesn't the cooling fan work on 1999 Jeep Grand Cherokee Laredo 4.0 liter Fan has been tested and is good?
Check your fuse, and your coolant temp sensor. The coolant temp sensor is more than likely the problem
Coolant leaks out of the top of the engine olds intrigue Doesn't seem to be a crack in the block What is it?
Where? Be more specific? Try to put a bit more detail in your question top of the engine could mean anything.
What does a Coolant Temperature Sensor do?
the coolant temp sensor( cts) reads the temp of the engine and adjust the fuel air mixture depending on the temp. if its cold out the sensor will adjust for more fuel to ease the start of the engine. ADDITIONAL: The Coolant Temperature Sensor measures the temp of the coolant, not the engine. The sensor controls the thermo fans on/off. depending upon temperature. The actual engine temperature sensor is on top of the engine and does not control the fans. If the fans do not switch on at any temperature, disconnect the 2 wire connector from the sensor (Usually at the bottom of the radiator) If fans start up with connector disconnected, replace the sensor.
How do you find and clean the coolant sensor - dashboard light indicates low coolant which is not true?
The coolant sensor is located on the radiator about 6 inche directly below the radiator cap on the engine side of the radiator. Remove the battery to gain access to the sensor. Release the spring clip holding the sensor and gently twist and pull the sensor out of the radiator. Disconnect the wire harness to remove the sensor from the car. Dirt may not be the problem. The sensor electronics are "potted". The potting may have have cracked allowing coolant to short out the sensor. I recommend replacing with a GM brand sensor rather than the available Standard brand name. Wholesale pricing of both is about the same and the GM part is more reliable.
