Want this question answered?
In vcd, input voltage controls the output current.e.g.jfet In ccd , input current controls the output current. e.g. bjt
No, There can't Be current without voltage
Current will flow as long as there is a difference of potential (a voltage) and a path for current to flow. So no power-control device is required for current flow but yes it will flow with a power control decive.
Voltage attempts to make a current flow, and current will flow if the circuit is complete. It is possible to have voltage without current, but current cannot flow without voltage. The answer is "yes",voltage remains the same as current moves through the circuit.As the voltage remains constant, current increases in the circuit.
Power = (current) times (voltage)Current = (Power) divided by (voltage)Voltage = (Power) divided by (current)
A: A RESISTOR is a passive component it cannot control voltage these components and/or current it can however limit
Triac is the current control device.
In vcd, input voltage controls the output current.e.g.jfet In ccd , input current controls the output current. e.g. bjt
No. A zener diode is a voltage limiter. Circuit design might create a current limiting response, but the basic control is voltage, not current.
That depends on the circuit - but note that in almost all real circuits the current is the dependent variable - you control the voltage and the current sets itself.
transistor is a current controlled device. as the current flows through the base of the transistor , it works like a close switch.
The difference between a current control device and voltage controlled device is that for current controlled device, the current is constant and the voltage is variable while for a voltage controlled device, the voltage is constant and the current is variable.
Voltage regulators (vrs) do not control current. For example, the resistors used to adjust the voltage on variable vrs only change the behavior of voltage but not current. Vrs have maximum current ratings, usually but not exclusively they are rated at 1 amp or 1,000 milliamps. To control current and avoid frying the vr you need to use a resistor in series with either the collector (Vin) or the emitter (Vout). It's also feasible to use a current regulator in the event the input current tends to fluctuate.
Voltage = (current) x (resistance) Current = (voltage)/(resistance) Resistance = (voltage)/(current)
Voltage = (current) x (resistance) Current = (voltage)/(resistance) Resistance = (voltage)/(current)
resistors is a most common electronic component and is used to control the voltage and current in a electronic circuit. resistors is inversely proportional to amount of power supplied,given by (power= voltage *current).
Exam paper question.