open the tailgate and look in between gap and you will find 2 hex type screws.
The brake light bulbs ar removed from the rear of the light assy . Take it off of the body.
Remove the wiring harness from the high mount brake light. Remove the retaining screws. Reverse the process to install the new high mount brake light.
Brake light switch might need to be replaced. Simpler answer would be a blown fuse.
Take out the two screws and replace one or both of the lamps.
Left the rear hatch and remove the headliner trim and headliner ( Partially). Unplug the brake light wire that leads to the light housing. Loosen 2 screws below the light and remove carefully.
how to change a brake light on 2002 Nissan altima
brake light flashing on 2002 jetta tdi
peel back the trunk liner.....should be two or three screws. unscrew and pull the entire light assembly out its a pain in the but!
Changing the rear brake lights and turning lights are very simple. All you need is a Philip screw driver and about 10 minutes. First, unscrew the two screws that hold the entire light assembly. Second, Uncrew the other screws to free the light strip. Pull out the bulb you are replacing and insert your new bulb. Place the light strip back into the light assembly and tighten the screws. Last, Place the whole light assembly back and tighten the two screws.
remove the 2 t15 screws in the taillight remove the assy. turn bulb socket out and replace
Open tailgate. Look for the two Philips headed screws located in the area typically occupied by the closed tailgate. Remove two Philips head screws. Gently pull the tail light assembly towards you. Rotate blub holders (brake light and tail light). Replace bubls or tail/brake light assembly. Installation is reverse of removal.
brake light switch, may be located above the brake pedal where it mounts under the dash, did you find any parts laying on the floor ? No I did not