The reason is because you have two flashers. One works with the hazard light circuit and the other works with the turning sigal circuit. Replace the flasher and if that does not work you should check for a steering column problem or a switch problem. Good Luck
you need to replace blinker can in your vehicle. the flashers and blinkers have separate flasher cans which is why your flashers still work but not your blinkers
The signal and emergency flashers are located behind the lower dash panel aprox in the center. You need to remove several small screws to drop this plastic panel. Once it is off the flashers are visable.
It's not a fuse. It is a flasher relay that operates either the signal lights or the emergency 4 way lights.
That is not a fuse. It is a flasher relay for either the signal lights or the emergency flashers. Where they are located depends on what year the truck is. Most likely they would be found behind the lower plastic dash panel aprox under the radio. The lower dash panel has to be remove to gain access to the flashers.
Yes you can, as long as you have a amp and a properly working pickup it with pickup the pitch and amplify it.
Both the signal and 4-way flashers are located behind the plastic lower dash panel aprox under the radio. The lower dash panel must be removed to gain access to the flashers.
on a 1989 Isuzu pickup you need to take out the left speakerto get to the signal and hazard light flasher ..The control box for the flashers and turn indicators is all contained within the steering column. Not the easiest to get to.
Both the turn signal and 4-way flashers are located behind the plastic lower dash panel, aprox under the radio area. The lower dash panel must be removed to gain access to the flashers.
hazards and turn signals have separate flashers. replace flasher for turn signals
their is not one
Not bled properly or not adjusted properly.
Brakes dragging? Emergency brake not releasing? Rear brakes not adjusted properly? Frozen front caliper? Bad "U" Joint? Bad master cylinder- not allowing fluid to return to resevoir?