I don't know! I was hoping this site would tell me.
It is mounted up under the truck right next to the gas tank, in front of it.
The evap control valve is on the cannister
evap vacuum cut valve bypass valve
P0443 - EVAP control system CANISTER PURGE VALVE CIRCUIT MALFUNCTION - VPWR circuit open - Evap canister purge valve circuit shorted to ground - damaged EVAP canister purge valve - EVAP canister purge valve circuit open - EVAP canister purge valve circuit shorted to VPWR - damaged PCM
where is the evap purge valve located in a 1996 jimmy
In the 2001 Toyota Corolla the evap purge solenoid valve is located near the underside of the air cleaner. This is an emissions control device.
Check out this website for it's location b15sentra.net/forums/showthread.php?t=142973
This usually indicates a faulty Evaporative Emission (EVAP) Vacuum Cut Valve/Bypass Valve.1. Verify battery voltage to the EVAP vacuum cut valve bypass valve on the Black/White wire with the key ON.2. Verify the Green/White ground wire for the EVAP vacuum cut valve bypass valve is good all the way to the ECM. The Green/White wire goes to terminal 117 on the ECM.3. Verify the EVAP vacuum cut valve bypass valve is closed (can not blow through it by mouth) when the EVAP vacuum cut valve bypass valve is de-energized.4. Verify the EVAP vacuum cut valve bypass valve opens (can blow through it by mouth) with the valve powered up and grounded.5. Check the EVAP vacuum cut valve to verify it allows flow only one way.
it is most likely your evap canistor and/or valve. its located next to the gas tank and is usually the problem. other reasons could be leak in the evap lines (unlikely because this throws a p0442 code) or the gas cap (which you can look at and see if there are any cracks in the seal). in the case on my 07 silverado 1500 classic it was the valve which costs me $36 in parts, 45 minutes of labor, and 3 hours of research. the part number for mine is 25932571. make sure it is compatible with your truck for i am 90% sure it will be the same.
p1446
Where is the evap purge control valve located on a 96 camaro
YOU WILL FIND IT MOUNTED ON A BRACKET UNDER THE TRUCK BY THE FUEL TANK