Follow the 2 pin connector from the top of the coil located on the driver side front of the distributor. It should lead to a 2 pin connector, as well as a 4 pin connector. This is the ignition control module.
The engine computer is also the ignition module.
The engine computer, next to the battery, is the ignition module.
It is on the left side of the engine. You will see a coil and that is the module also. It is one unit.
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
The engine computer is the ignition module.
The engine computer is the ignition module.
Passenger side of the firewall, the engine computer is the ignition module.Passenger side of the firewall, the engine computer is the ignition module.
inside the distributor
the ignition module is in front of the lft front wheel,inside the fender. the module wiring harness runs thrue a hole /gromet in the fender into the engine compartment just in front of te ignition coil.
The ignition module on a 5.7 Chevy engine should be on top of the motor. It is mounted beside the distributor.
ignition module
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.