This is so easy to find seriously! It is mounted right across from the oil filter with a single wire terminal that screws into the block! To remove disconnect the wire connector,unscrew the oil pressure sender and when reinstalling the new sender use some permatex thread sealant(white in color) sold at auto zone,advance auto,napa for under 4.00 and place a 1/4 of this on the threads of the sender and screw in by hand and tighten lightly(I and not more than hand tight) with a set of channel lock pliers.The sensor should be available at most auto stores as a in stock item.Ok
In the fuel tank.
The map sensor is on the air intake line to the throttle body....
In between the bumper and the frame, on the passenger side.
No
behind the radiator,in the middle of the engine
where is the fuel pump on a 89 Mazda b2200
Coolant temperature sensor is locatedat the front of the intake manifold near the upper radiator hose.
Who is a valve calibration for mazda b2200 1988
where is the EGR valve on a 1989 mazda b2200
The attached links should answer you're question. Kyrasis6 Mazdatruckin.com
The 1992 Mazda B2200 will hold close to 17 gallons of gas. The 1992 Mazda B2200 is a four-cylinder vehicle.
92 b2200 ,fuel injection psi should be 38 to 46 psi