answersLogoWhite

0

you loose brake pressure when u start engine. this is supposed to happen. pedal will be hard until engine is started and the vaccuum pump works to assist the poer brakes

if the pedal goes to the floor , maybe you need to adjust the brakes. if the vaccuum pump is not working , it will feel like you are standing on a rock when you try to use brakes

a good indication of out of adjustment or worn brakes is to look at brake fluid resevior.if fluid is not at proper level, do not add fluid, but check and replace worn disk pads on front, and replace or adjust shoes on rear

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you reset brake proportioning valve on 1995 s10?

To reset the brake proportioning valve on a 1995 Chevy S10, start by locating the valve, typically found near the rear axle. You'll need to bleed the brake system to ensure any trapped air is removed, which can help reset the valve. If the valve has tripped due to uneven brake pressure, gently tap it with a hammer while applying the brakes to help reset it. Finally, check the brake fluid level and ensure there are no leaks before testing the brakes.


When i try to start my 1995 dodge avenger there is no fuel pressure won't start?

Fuel pump is bad.


How to tell if abs brake pump is bad on 1994 Chevy beretta?

it is a 1995 Chevy blazer and it will not go into park. have to use the emergency brake when stopped, and neutral to start it


What is the function of the block that all your 1995 ford Taurus rear brake lines run into?

That is the Rear Brake Proportioning Valve (also referred to as a Rear brake pressure regulator). Depending on the suspension position, it changes how much pressure is sent to the rear brakes. Depending on the situation, it may increase pressure (usually during high rear load conditions) or decrease the pressure to prevent unpredictable handling.


What are the release dates for The Pursuit of Happiness - 1995 Losing It 1-5?

The Pursuit of Happiness - 1995 Losing It 1-5 was released on: USA: 31 October 1995


What do you do next when your 1995 Oldsmobile Aurora brakes lights won't work and you've replaced light bulbs and fuses and the brake pressure switch under the brake pedal?

Check, or even better replace, the wires.


How do you adjust the emergency brake on my 1995 Nissan 240sx?

The 1995 Nissan 240 emergency brake has an adjustment screw on the brake pad. Turn the adjustment screw to adjust the brake height.


When was Losing Isaiah created?

Losing Isaiah was created on 1995-03-17.


1995 Ford Explorer Eddie Baurer will not start. I have spark and fuel pressure but it will not turn over.?

Type your answer here... will not start to still run


How do you change the brake booster in a 1995 GMC Jimmy?

Begin by removing the brake lines from your 1995 GMC Jimmy brake booster. Remove the brake booster retaining bolts. Reverse the process to install your new brake booster.


On a 1995 Ford F-250 where can you find the wiring harness for a brake control?

on a 1995 ford, there is no brake control harness.these are added by who ever installs brake control


Where is the brake relay 1995 Nissan pickup?

on your brake pedal lever.