There's a little black electronic comp. sensor chip on the key from the factory. If it's missing,your computer thinks someones stealing the car.
Connect the positive cable to the positive battery post on the donor car and on the Corvette. Connect the negative cable to some metal part of each vehicle, such as the engine. Be careful of the fan blades on each car. Let the donor car run for approximately 15 minutes to put a slight charge in the battery on the Corvette before you attempt to start it. Start the Corvette and as soon as it starts disconnect the battery cables.
When a vehicle starts from rest, you may experience a slight jolt or movement as the engine engages and the vehicle begins to move forward. You may also hear the engine revving as it builds up power to propel the vehicle. Additionally, you may feel a gradual increase in speed as the vehicle accelerates.
The cheapest the Corvette Coupe starts at $49,600 and the most expensive is the Corvette ZR1 which sells for $112,600. Click the link.
on the vr6 engine the factory thermostat is 180 but the engine should not get over 210 at 180 the thermostat starts to open and is fully open at 195
I don't have an answer for you except that you can go to Autozone and they will check your computer for free if your check engine light is on. I don't know what year model this starts at, but it's worth a try so that you don't have to guess!
ANSWER: It is the check engine light. It starts out a yellow meaning that there is some thing going on and have it looked at soon. If by chance the little engine light is red, this means do not drive your vehicle until you have it serviced. There are many things that could cause this to happen from fueling the vehicle with it running , a sensor not functining properly, or a major engine problem. It is not to be taken litely if it is red, you could severly damage the engine if you ignore it.
First disconnect the mass air sensor and see if the vehicle starts
Amphibious_vehicleAmphibious Vehicle
Aircraft
Flooding an engine simply means that there is TOO much gas in your cylinders, and you have to wait until they drain before you press the gas, or start the vehicle. The more you try to turn the vehicle over, the more gas will be injected. So let the vehicle sit and wait or press the accelerator to the floor to increase the air in the mixture and leave it there until the engine starts.
The 2014 model year starts in Sept 2013.
Audi