it will be depend on the application, however following material are generaly used for pipe sealing -asbestos sheed - PTFE -composite sheet(Rubber+asbestos)
Of steam seal on a steam turbine temperature in incorrect could cause damage. This could cause it not to work right.
There are a number of sealants available to prevent leaks in pipes. If you don't want to use teflon tape, you can use a liquid sealant which will form a seal as it dries.
In a mechanical system such as surface to surface movements or a mechanical seal normal lubrication does nor penetrate in the gaps where lubrication is essential due to force / pressure in the mating part or seal. Lubrication in this case is forced into the joints by applying pressure resulting in forced penetration of lubricant.
With duct tape I install and maintain duct work for a living if you want to seal the joints just wrap the tape around the duct. If you need to cover a hole you will need to screw a piece of metal on the duct over the hole and tape over the edges of your patch. this is the simplest and cheapest way I know to do it.
A stuffing box is an assembly which is used to house a gland seal.[1] It is used to prevent leakage of fluid, such as water or steam, between sliding or turning parts of machine elements.
Yes, wherever there is a joint between 2 pipes, use exhaust sealant to prevent a bad seal between the pipes, which will prevent it blowing.
Seal.
Of steam seal on a steam turbine temperature in incorrect could cause damage. This could cause it not to work right.
Secure the pipes. Use spray foam on the pipes, drain lines so no holes or leaks .
The answer depends on the fabrication materials of the walkway.Contact the materials' vendor and ask whether water-seal is recommended, and if so, what products are recommended to seal the walkways.
Yes, if the crown weir is not covered by the trap seal.
You have to fill the can with steam and then seal it closed. when you then put the can in cold water the steam will condense into water and the can will be crushed by atmospheric pressure.
You can use epoxy resin to seal large holes or cracks in plumbing pipes because it is impervious to water and oils.
It is possible the seal is just worn out but check the driveshaft u-joints. If a u-joint is bad it could cause the driveshaft to wobble putting extra strain on the rear seal.
Yes, wherever there is a joint between 2 pipes, use exhaust sealant to prevent a bad seal between the pipes, which will prevent it blowing.
It's colder in the basement than the water coming in the pipes. Seal up the vents and drafts in the basement. Wrap the pipes
MANY things. Duct tape can seal cracks in ducting - it's original purpose. It can join different pipes and seal them. It can be used to attach a number of things together.