Hi
Assuming these are for a six-cylinder engine, the basic numbers, stamped on the body just below the cap, are:
40546B for the high-compression head (7.8:1) - low tension terminal normally has a red washer
40545A for the low-compression head (6.9:1) - low tension terminal normally has a green washer
For Australian models the above numbers may become:
DM2-40546B for the high-compression head (7.8:1)
DM6-40545A for the low-compression head (6.9:1)
When points are fully open, loosen the two main screws to get close to initial setting (below), then perform fine setting of points by turning the small eccentric screw in the adjustable contact plate. Tighten the main screws and re-check setting.
Set points gap to 0.012 inch - if this promotes difficult starting increase gap to 0.013 inch and re-try. If this is unsuccessful use the factory 0.014 inch setting.
The knurled adjustment wheel minutely adjusts timing to suit different grades of fuel.
Hope this helps
Cheers
Info on Lucas distrubutor applications can be found o http//www.mgaroadster.co.uk/lucas.pdf. According to this, the distributor fitted to Wolseley 1939-48 is DY6A pt no 40051A/B
Lincoln maded a model in the U.S. called the Zephyr from 1936-1940. Ford also made a model called Zephyr in England from 1950 to 1972.
Based on typical naming conventions - 36 - in the model number indicates 36,000 btuh nominal or 3 tons.
The value of a Smith-Corona Zephyr 1938 typewriter depends on its condition. This model in excellent condition is valued between 350.00 and 425.00 as of 2014.
champion j-6 gap at 25-30
LPT3118
Nedd the following information; Year model: Engine size: V8/V6:
The number that follows the letters "LIST" on the airhorn of the carb is like the part number. Do a search with it on the net and you should get something straight away.
sales
sales
If it is the original factory fitted radio take the model and serial number to your dealership with your VIN. They should be able to tell you the code.
AnswerWhat make, model, engine, and year Buick?1993 sedan 5.7L roadmaster, please help!!