No
if you run the unloaded motor at max rpm the centrifugal forces will cause the motor to be totally destroyed so it is advisable to not to run it at max rpm it should be okay to run it till 50% of max rpm without loading it
The formula for RPM is ; RPM = Hz x (120 (constant)) divided by the # of poles. Number of poles a motor has; # of poles = Hz x (120 (constant)) / RPM.
You would use a worm drive meshed with a gear that has 130 teeth.
No. With the values given the motor will run at 1500 RPM. RPM = Hz x 60 x 2/# of poles. The only way the motor can be run at that speed is by using a VFD as its source of power.
ac universel single phase motor
Because your motor is spinning faster at higher speeds causing higher rpm's
Materials for producing 2900 rpm motor is less than 1450 rpm one
No
The engine is not meant to run at high rpm's at a stop for a long amount of time. The motor cant circulate antifreeze and there is no air to cool the motor at a stop. Any car will do that. What a stupid answer! I didn't say I was stopped!
Relationship between motor rpm and no of poles
if you run the unloaded motor at max rpm the centrifugal forces will cause the motor to be totally destroyed so it is advisable to not to run it at max rpm it should be okay to run it till 50% of max rpm without loading it
I believe redline is 5,000 RPM.
Yes, that is how they are made
It might be a worn/broken motor mount.
No. The water pump is designed for a specific RPM. It will not operate correctly, and will probably be damaged, if you attempt to operate it at twice the design RPM.
The formula for RPM is ; RPM = Hz x (120 (constant)) divided by the # of poles. Number of poles a motor has; # of poles = Hz x (120 (constant)) / RPM.