0
Because your motor is spinning faster at higher speeds causing higher rpm's
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What does it mean when you car overheats at high speeds and when stopped rpms go up and down while in neutral?
check egr valve
What makes a car have no power at slower speed but not at high speeds?
Probably a matter of where the engine's power band is set out, or you may simply be bogging the engine down at lower speeds. Try downshifting and keeping your RPMs up a little.
What is better low or high rpms?
lower rpms use less gas higher rpms have more power
What is the shifting speeds for an 18 wheeler?
That depends on what your rear end gear ratios are. It varies greatly. As a default, you typically upshift at 1500 RPMs and downshift at 1000 RPMs.
Do you use the fifth gear of a Geo Metro?
You most certainly do, it is called overdrive. You may be able to achieve high speeds in 4th gear, BUT you can also acheive those speeds in 5th gear but with lower RPMs, thus resulting in an increase in fuel economy
What is considered a fast hard drive?
Fast speeds on a hard drive are important if the drive is going to used for gaming. The average speed of a hard is around 7500 rpms. If it is being used for gaming, a faster hard drive with speeds of upto 10000 rpms should be used.
Why would a car shake after starting and have high RPMs like 3000 RPMs and 55mph?
major vacuum leak?
What is the normal RPM range driving at highway speeds for a 1994 Jeep Grand Cherokee SE?
2-3 rpms
When was Games at High Speeds created?
Games at High Speeds was created in 2003.
If the transmission is in need of service will it cause the car to idle and run rough at low rpms yet run smooth at high rpms?
no
Why are bullets coated with copper?
The copper jacket is needed to push bullets at very high speeds and to withstand the very high rpms generated by the rifling. A lead bullet would fly apart because it is too soft. The harder copper jacket keeps the bullet in one piece.
What could be the problem if your 1990 Plymouth laser rs rpms are to high you have changed the iac motor and the engine comp because the mecahnic said that was the problem but the rpms are still high?
did they want freedom
