The error code inidicates one of two things. It is either a burned out SRS light or there is a problem with the SRS system that is being detected durng the initialization process. When there is an error, the chime will sound 5 times, pause and repeat. It will do this about five times and stop. If the engine is left running for 30 minutes, the sequence will repeat.
With the engine OFF, parking brake ON, and the seatbelt UNBUCKLED, Turn the ignition to the ON position without starting the engine. When the seatbelt light goes OUT, buckle and unbuckle the seatbelt 9 times, ending with the seatbelt unbuckled (This must be completed within 50 total seconds). The airbag light will light for 3 seconds, when is goes out, buckle and unbuckle the seatbelt 1 more time within 7 seconds. If you were successful, the seatbelt light will flash 4 times per second for 3 seconds.
Get in the vehicle and latch the seatbelt. Turn the key to "on" not "start". Wait for the seatbelt light on the dash to go out. Unlatch and relatch the seatbelt buckle 3 times within 10 seconds. Waiting for the the seatbelt light on the dash to come on before each relatch. End with the seatbelt latched. Turn the key to off. A single ding indicates success. Complete the above steps all within 60 seconds. If you hear any dings during the process you must start over.
48 seconds if you are driving in a straight line it takes 0 seconds
Wear your seatbelt!! ;P A better solution?? Yes seatbelts save lives! I obey the law and wear mine when Im driving on public roads. But what about when you are on private property or on dirt roads hunting and fishing? A seatbelt is not necessary in these instances and is irritating to say the least when you have to buckle up with no good reason to have silence in your vehicle. There is a new product out that you will love that fits most cars and trucks!! It installs in seconds and can be disconnected in seconds if you wish to. Get on the net and type in "seat belt alarm stop". Enjoy your legal right to silence in your vehicle! Lou
1.5 seconds
The 3 seconds file on driving refers to what?
1,668 seconds
You have to put on your seatbelt for like 10 seconds then take it off then but it back on for another 10 seconds then take it off. That will stop the annoying beeping.
To state the obvious - wear the seatbelt. There are reasons to disable the chime. 1. Turn key to accessories "on" 2. Wait for seatbelt light to turn off and then press the seatbelt release button 9 times. 3. The abs light then illuminates for 5 seconds, when it turns off, press the seatbelt release button 1 more time. 4. The abs light will blink to confirm the code was entered. 5. This must also be done on the passenger seat.
Insert key into ignition ,buckel seatbelt,and turn key to on ,but do not start engine. Within 60 seconds, Unbuckel and buckel seatbelt 3 times. Cycling seatbelt indicater on and off . Red led in lower right of guage cluster will flash three times to indicate reprogram.
The duration of Related is 2700.0 seconds.
you can disable the seat belt chime by connecting and disconnecting the driver's seatbelt 20 times in 30 seconds with the key turned to on (not running). I've found that it's more important to make sure the seatbelt fully connects and disconnects than worry about the 30 seconds.