Yes. Or the motor has just burnt out! If there is no burnt smell from the motor's windings and you know the power supply to the fan is good, it is worth replacing the capacitor with an identical one. NOTE: It must not be a polarised electrolytic type, it must be non-polarised and rated at the peak mains supply voltage or higher. Such capacitors are usually sold as "AC Motor Start" or "AC Motor Run" capacitors. For a 120 Volts motor use a capacitor rated to operate at 170 Volts peak. Usually these are manufactured to handle at least 200 Volts Peak AC . For a 240 Volts motor use a capacitor rated to operate at 340 Volts peak. Usually these are manufactured to handle at least 400 Volts Peak AC. <><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
Bad fan motor or bad capacitor.
There are three main parts to an air conditioning unit. You could have a bad capacitor. AC units have fairly large capacitors that are required for the motor to start. That is the most likely point of failure. Otherwise, your compressor could have gone bad. Lastly, your fan motor could have gone bad.
Be certain to observe the exact same polarity as the old one. A capacitor does have plus and minus leads. Should an old defective ceiling fan transformer be replaced by a capacitor?
No, it is the capacitors effect upon the motor's winding that starts the fan to turn.
One of your capacitors in the fan is not operating. I had the same problem. If you still have the high speed working on the fan there is a work around. If it is the high speed capacitor that is gone, take the fan apart and use one of the other capacitors to replace it. Use one that is closest to the rating of the high speed capacitor. In the high speed run the fan will not be using the internal fan capacitors for the lower speeds, so cap the wires off with wire nuts that come from the fan motor to the capacitors. Move the connections around until you get the high speed position to work. This work around requires that there is a wall switch that operates the fan. A Lutron model number DVFSQ-F will work very well with the fan. There is a toggle on the right side of the switch that selects the speed, low, medium and high speed. Depending on the position of the slider switch, that is the speed the fan will start in. The new fan switch is wired just like an ordinary light switch.
If it is the outdoor fan, it could be a couple of things. 1. Bad fan capacitor 2. Bad fan motor 3. Loose wire If indoor blower the same apply, but it could also be a bad fan relay.
Yes it can. If the fan is not coming on you could have a bad fan motor, a bad capacitor, a loose wire at the contactor, or a loose wire at the capacitor.
Yes, but usually one side of the capacitor will completely go out. Either the fan or compressor will not work. First look at the capacitor. Usually they swell and the cylinder shape becomes rounded on the bottom or top. If you know how to work a meter, disconnect the leads on the capacitor and check for continuity (ohms). Put one lead on the Common and the other or Herm then move it to fan. Look for a rise and fall in ohms. If its bad, continuity will be lost on either side. Depends on what you are trying to repair, fan or compressor.
Check to see if the capacitor is good. It is usually located inside the outdoor unit. It could be that the capacitor is bad and needs replacing. The outdoor fan will still run if you have a dual capacitor. One sure sign of a blown capacitor is that the top of the capacitor is bowed outward. If you have a multimeter you could also check the amp draw on the condensing unit. I would look at the capacitor first though
It could be that the capacitor is going bad or the bearings in the motor.
In the central ac system it could be a few diffrent things that are not working, that is causing the fan not to blow. Their could be no power to the outside unit, a bad contactor, a bad capacitor, or your high pressure switch could be shut down.
Bad fan motor or bad capacitor.
There are three main parts to an air conditioning unit. You could have a bad capacitor. AC units have fairly large capacitors that are required for the motor to start. That is the most likely point of failure. Otherwise, your compressor could have gone bad. Lastly, your fan motor could have gone bad.
capacitor stores charge ,so we use capacitor in fan for continuous voltage supply.
by changing the polarity of capacitor of single phase ceiling fan can we change the direction of rotation from anticlockwise to clockwise
CAPACITOR STRAT AND capacitor run of a induction motor
capacitor is a power cell used to generate electricity in the motor of ceiling fan