answersLogoWhite

0


Best Answer

If brakes are squeeking and you are low on brake fluid Probably time for new linings or pads, I would check them before just adding brake fluid. Brake fluid resevior should be located on firewall on driver's side

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: My breaks squeek and their no metal to metal grinding and i need to know where to put in the brake fluid on a 98 Plymouth breeze?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Your breaks squeek but your break pad are good?

oil your breaks


Why do my Front breaks squeek on 1995 f-250?

6


Your brakes squeek why .i have a 95 Monte Carlo?

my brakes squeek do i need new brakes??? More than likely it's just a build up of brake dust causing the squealing best advise I can offer is to have the brakes checked & cleaned As long as the brakes are not grinding you should be OK for a little while


What is the crunching noise from your brakes?

Does it squeek? Or is it grinding? Possible sand/ gravel trapped in your brakes. Or you need some new pads. If it's during winter and you break hard and start sliding.. then it would be your ABS kicking in.


What causes a squeak if not the breaks on the front tires on a 1992 dodge dynasty?

Could be the belt in the tire, that can cause it to squeek, also it could be the wheel bearing or the C/V Joint.


Why would a Pugeaut 106 quiksilver make a grinding noise with a slight squeek in it when you let off the gas?

Sounds like bad wheel bearings Also check transmission output shaft bearing and u joints


What rhymes with squeek?

geek.


How many syllables does squeek have?

Only one.


What happens when a guinea pig bites it lip?

it will squeek


When do you change the brake pads on a Jeep Wrangler?

when they start to squeek


What happens when a front control arm bushing breaks?

You will hear a loud grind or metalic squeek or knock when you go over a speed bump. It will also cause the whole suspension assembly to vibrate or wobble at high speed. It also can affect handling in corners.


Why does the AC compressor squeek when starting the car?

Loose or worn belt?