How to change hazard and horn reminder mode
When LOCK and UNLOCK signals are sent from the remote controller for more than 2 seconds at the same time pressing both buttons, the hazard and horn reminder mode is changed and hazard warning lamp flashes and horn sounds.
The beep function on the remote may be deactivated. To reactivate, simultaneously hold both the lock and unlock button for about three seconds. The car should chirp and the lights flash.
Nissan remote programmingThis is very simple and works for most Nissan models 1) get in and lock the doors with the power door lock on the drivers door2)Insert key into the ignition 6 -7 times in 15 seconds3) Hazard lights should flash4) put key back into ignition and turn to accesory5)Press the master door lock( on th edrivers doo arm rest) unlock/lock6) hit the lock button on the remote7) Hazards should flash7a) if yo have a second remote repeat step 5, 6 and 7 at this point for the second remote8) pull the key out of the ignition and open and close the drivers door ( if you do not open the door and close it fully the process won't work)9)the remote/'s should be setOnce the remote is set: Xterra has 2 un/lock modes: Silent & Noise.Silent- when locking-- no horn will beep but lights will flash.when unlocking - no horn , no lightsNoise- when locking - Horn beeps and lights flashwhen unlocking - lights flash ( no horn)To change from one mode to the other simply stand near the driverside front light. Press and hold both unlock and lock buttons for 5 seconds on remote. Horn will sound and lights flash. Your done
Nissan remote programmingThis is very simple and works for most Nissan models 1) get in and lock the doors with the power door lock on the drivers door2)Insert key into the ignition 6 -7 times in 15 seconds3) Hazard lights should flash4) put key back into ignition and turn to accesory5)Press the master door lock( on th edrivers doo arm rest) unlock/lock6) hit the lock button on the remote7) Hazards should flash7a) if yo have a second remote repeat step 5, 6 and 7 at this point for the second remote8) pull the key out of the ignition and open and close the drivers door ( if you do not open the door and close it fully the process won't work)9)the remote/'s should be setOnce the remote is set: Xterra has 2 un/lock modes: Silent & Noise.Silent- when locking-- no horn will beep but lights will flash.when unlocking - no horn , no lightsNoise- when locking - Horn beeps and lights flashwhen unlocking - lights flash ( no horn)To change from one mode to the other simply stand near the driverside front light. Press and hold both unlock and lock buttons for 5 seconds on remote. Horn will sound and lights flash. Your done
No.
You would disconnect the battery terminals.
be cause your bulb is blown out
How to change dashboard lights in primera 1999?
The fuse box is located under the hood next to the battery.
There is a fuse box under the hood (passenger side). I know the the fuses for the head lights are there. The fuse for the taillights is there and is labeled. This fuse includes the running lights but is not labeled as such.
Turn up your dimmer switch. Should be next to the steering wheel on the dash board.
To turn off the alarm, you insert the the key in the drivers door lock and turn the key to the right two times.
XTERRA Triathlon was created in 1996.