There about 3 basic sizes that were on that van originally, and for all practical purposes the G10 and the G20 vans used the same size axle from 1985 thru 1995, however it may be a little hard to find a van with the same axle ratio, (for example, 3.42 or 4.10), which you probably want to do just so you won't have to have your speedometer recalibrated so it will read correctly.
You need to put some gear lube into the rearend....any local autoparts store will have some.
As I don't own one there is no need to strengthen it.
And what about it do you need one ? selling one ? Fixing one?
models need special education
1) The drive belt could be broken. 2) The rearend could be bad 3) The brake on the rearend could be stuck. (this would make the rear tires lock up) 4) The pulley on the engine or rearend could be the problem. You need to do a little investigating to see what is going on where.
do models need a spaecial education
No, you don't need to mess with the rearend whatsoever when changing the driveshaft.
No you need a rearend from another G-Body
You need the speed to do the conversion. The formula is distance = speed x time.You need the speed to do the conversion. The formula is distance = speed x time.You need the speed to do the conversion. The formula is distance = speed x time.You need the speed to do the conversion. The formula is distance = speed x time.
I'm sure it will, But you need to measure both of them first.
You cannot without a lot of other information. You need the shape and other dimensions of the solid/liquid to calculate its volume. You then need to apply density. You also need to apply unit conversion factors.
Conversion means to change what every it is you need to convert.
Rw is measured in units of dB, there is no need for conversion.
No. Models do not need to have a license, certificate, diploma, degree or any other kind of certification.
Yes. It will fit. If you stay around the year 92-95 engine and car models you don't have to change much with your wiring harness which is OBD1. And 96 - and up year models are obd2. And since your car is OBD1 and ( For Ex. ) want to use a 96 - and up engine models then you would need a conversion harness or just swap out the whole wiring harness. But using a conversion harness saves more time and is way easier.
very carefully lol. get a hanes manual! it wil tell you everything you need to know
yes because they do good stuff for other communities and help people when they need help
i need answer
David didn't need conversion. He was Jewish, and was taught Torah, from birth.
Scientific models need to be changed whenever a model is proved to be wrong through discovery of new evidence.
No, You can even give out free models, If you are NBC.
well you have to take the exaust off then you need to take the gas tank off or lower it some then you need to undo it from the rearend then take the drive shaft out!
To be a catalog model you will need to have a good modeling agency representing you. Your agent will find you work with clients that are in need of catalog models.
The PS3 slim has 2 models one with 120GB harddrive and the other with a 250GB harddrive