You could just unhook your negative battery cable.
unhook neg battery cable then wait 10 mins for disgarge of capaciter then proceed to change ignition
There is no way to disarm a driver airbag on a 1994 Dodge Ram. Most vehicles will only let a person disarm the passenger airbag.
It is illegal to disarm an air bag.
Remove the fuse.
I wouldn't do that but if you unplug any of the sensors it will cause a fault which will disarm them. But you will get a warning light on your dash all the time.
Don't do that!It's a major mistake to do that!The airbag is a safety device.
Run it in to a tree???
The only way on that year model is to unplug it. You can go up above the glovebox, and you will see the connector. There is no disarm switch on that year Explorer. The airbag light is going to flash and illuminate after you do, but that is the only way.
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
To disarm the alarm on the 1998 Ford Contour, simply turn on the ignition using the vehicle's key. You can also disarm the alarm using the key fob.
you will see a small hole directly below the key cylinder turn the ignition to "run" not "on" put a wire or punch in the whole to disengage the retaining pin while pulling on the lock cylinder at the same time. ALSO DISCONNECT THE NEGATIVE BATTERY CABLE AND AS A PRECAUTION DISARM THE AIRBAG.
Insert the ignition key into the ignition and turn it to on, the alarm should shut off.