answersLogoWhite

0

New York Air Brake wont pump up?

Updated: 8/18/2019
User Avatar

Wiki User

11y ago

Best Answer

Get it diagnosed and repaired.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: New York Air Brake wont pump up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When was New York Air Brake created?

New York Air Brake was created in 1890.


Why wont your brakes pressure pump back up after you replaced your rear brake pads on a dodge ram 2500 series?

bleed your brakes there might be air in the lines or the brake booster is bad try to bleed all 4 brake 1st


Why wont brake pedal get hard?

You must have air in the system. Get your brakes checked ASAP !


Why wont your bb gun hold the air you pump?

Most likely it has a blown seal.


1997 f150 brakes wont build pressure no air in the lines?

Check your brake power booster


Is there a air brakes endorsement in New York state?

Air brake endorsements fall under Federal laws so every state will have the same minimum requirement for an air brake endorsement if you have air brakes on your vehicle.


Where can I find some York heat pump parts?

York's website can point you in the direction of a local dealer where you'll be able to find a lot of York heat pump parts. "Air Dynamics has a bunch of York heat pump parts, as well as parts for other York products."


Power trim on my boat that has a handle you pump to raise the motor it lost oil and now it wont pump up afrer adding more oil how do i get it to pump?

Get the air out first..


Why would a car stall when braking only once in a while?

bad booster pump or air in brake lines


Car is firing but wont start?

fuel pump, timing belt, air intake (sensor), fuse, distributor...


Can a car run right if you take the smog air pump off?

Yes, it wont cause your vehicle to not run.


What is brake system bleeding?

Brake system bleeding is working on hydraulic brake systems. This is when the brake line has air bubbles in the line. You open the bleed screw on the caliper and pump fluid through the lines until all of th bubbles are gone from the system, an air bubble will steal pressure from the brake system and prevent good operation.