answersLogoWhite

0

What else can I help you with?

Related Questions

How do you get a power seat moved back once the motor is dead?

To get a power seat moved back once the motor is dead there needs to be a handle on the side. If no handle, you will need to remove the seat, unplug the motor, and replace with a new one.


How much power can a 06 wrx motor handle?

safely upwards of 350 without being built


Which engine is better b16 or b18?

Many Honda enthusiasts agree that the B18 is the better motor. The B18B or B18C is a better motor than the B18A. The B18 is a very good overall motor that can handle a lot of power on boost, make a pretty decent power all motor, and are high-revving.


Repair a power window motor on a 2000 Chevrolet Impala?

I went to eBay and purchased a new motor and installed it myself. Just take the two screws loose in the door handle and pull up. The window motor just snaps into the door handle. Unplug the old motor, plug in the new one, and put everything back together. It only took about 5 minutes. This procedure is for the power window and window lock master switch.


What wattage 12 volt inverter do you need to drive a 240 volt quarter horsepower pump motor?

You need to find the wattage of the pump motor. This is found by multiplying the voltage of the motor by the amperage of the motor. Once you have this figure use it to find an inverter that can handle this wattage load at a 240 volt output.


What is the difference between an AC servomotor and a DC servomotor?

With a DC motor, power is supplied from a controller and transmitted to the motor windings via brushes and a commutator using pulse width modulation. This requires that the controller be adequate to handle the power/heat of the application and that the brushes and commutator are well maintained as they are wearing parts. With an AC servomotor, the controller only provides a low power signal to any size motor. Raw power to the motor is handled separately from the control circuit. The control signal is used to control the position of the motor which has internal position sensing capability. Power to the AC servo is always on.


Draw a schematic diagram of a 3 point starter showing various components internal connections and out going leads connected to a dc shunt motor?

A schematic diagram of a 3-point starter for a DC shunt motor includes a few key components: a starter handle, a series coil (or relay), and a shunt motor connection. The starter handle is connected to the series coil, which is in turn connected to the armature winding of the motor. The outgoing leads connect the motor's armature to the power supply, while the shunt field winding is connected to the power supply directly. The starter allows for a gradual increase in voltage and current to the motor, protecting it from inrush current during startup.


Is an airplane a motor or a vehicle?

An airplane is a VEHICLE. It's power is provided by a MOTOR.


How do you find out what year a minn-kota trolling motor is?

The motor has a plate on the head or the handle with the model number on it.


How do you find out what year a minn kota trolling motor is?

The motor has a plate on the head or the handle with the model number on it.


What is the biggest motor you can fit in a s10?

As big as your wallet can handle.


Is your power into motor equal to your power out of motor at no load?

For a motor's output power to equal its input power, the motor's efficiency must be 100%. As no machine, particularly a rotating machine, can possibly achieve 100% efficiency, there is no condition under which its output power can ever match its input power.