answersLogoWhite

0

To wire a starter to a motor on the ground, first ensure the power supply is off for safety. Connect the starter's positive terminal to the positive terminal of the motor, and the negative terminal of the starter to the negative terminal of the motor. Use appropriate gauge wires to handle the current and ensure secure connections. Finally, double-check all connections before turning on the power to test the setup.

User Avatar

AnswerBot

3w ago

What else can I help you with?

Related Questions

Where is the ground wire to the starter on a 1996 corolla?

There is no ground wire. The casing of the starter itself is considered the ground. Ex. If you take a battery and use jumper cables to touch the positive lead to the wire terminal on the starter, and then touch the negative terminal to the metal casing it will spin the motor.


Where is the ground wire for a Chevy 305 starter?

The Chevy starter does not have a ground wire, the starter grounds through the starter casing.


Where is the ground wire of a 1999 Dodge Avenger starter?

In a 1999 Dodge Avenger, the ground wire for the starter is typically connected to the engine block or the transmission case. This connection ensures a proper ground for the starter motor to function effectively. You can usually trace the ground wire from the starter to its attachment point on the engine or chassis. Make sure to consult the vehicle’s service manual for specific diagrams and locations if needed.


Does the Volvo 240 dl have a ground wire going to the starter?

No, the starter casing acts as the ground.


Why 1994 cadillac conours wont crank or make any noise when you turn the key. starter battery alternator are good?

If the starter and battery are good then it has to be the wiring. What I have seen many times is the ground wire to the frame of the car is the problem, Be it loose or disconnected it would stop the motor from turning over. So check that the smaller of the black wires,coming from the battery,is connected good to the frame of the car and the larger of the black wires has a good connection to the motor. Another wire you would want to check,is the one comming from the key switch and going to the starter relay.If the wire is broken or has no power comming out of it the starter will not turn. So remember, for the start to turn,you need to have a good ground for the stater housing,power to big red starter wire and power on smaller wire going to the starter relay. If the starter and battery are good then it has to be the wiring. What I have seen many times is the ground wire to the frame of the car is the problem, Be it loose or disconnected it would stop the motor from turning over. So check that the smaller of the black wires,coming from the battery,is connected good to the frame of the car and the larger of the black wires has a good connection to the motor. Another wire you would want to check,is the one coming from the key switch and going to the starter relay.If the wire is broken or has no power coming out of it the starter will not turn. So remember, for the starter to turn,you need to have a good ground for the starter housing,power to big red starter wire and power on smaller wire going to the starter relay.


Where is the starter ground wire on a 2000 gm sierra?

there is no ground wire it is grounded through the case


Why can i not get my car to turn over with a new battery it's a 2005 Chevy equinox?

Could be a defective starter motor, or broken ground wire.


Where do you put the ground wire from the starter on a 1991 s-10 blazer 4.3?

There is no ground wire from the starter. You should have one large wire from the positive battery post that connects to the large stud on the starter solenoid and one small wire that attaches to the small stud on the starter solenoid.


Where can you find the starter motor on a Skoda octavia?

Follow the positive (+) wire from the battery it goes straight on to the starter motor.


What wire is the hot wire and ground wire in a 1990 cutlass supreme?

the hot wire goes to the starter and the ground wire bolts to the engine block.


How do you replace A starter on a 2000 Pontiac Montana?

two bolts on the starter motor and a plastic bracket covering the starter motor unscrew big wire nut and there is also a small wire to unscrew makesure negative wire to the battery is off


Can a bad ground wire affect the starter?

Yes