answersLogoWhite

0


Best Answer

If a 1996 Isuzu Oasis 22 does not have fire to the plugs after changing the timing belt, perhaps a spark plug wire got crossed when hooking up the spark plug wires. Check the coil to make sure the right firing order is being used. Check to make sure the distributor did not accidentally get turned when changing the distributor cap. Also, check the wires to the distributor.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: No fire to plugs.1996 Isuzu Oasis 22 Running fine broke a timing belt Replaced the belt now cannot get fire to the plugs Timed correctly new distributor new cap and coil 12v to the distributor.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would a 1988 Honda CRX jerk and stop as if it is running out of gas?

Answercheck distributor. eg with timing light to ensure its working correctly


What would cause a 1957 Chevy to backfire and not stay running?

Incorrect timing, spark plug wires not installed correctly, timing chain worn out and has jumped a tooth, or distributor worn out.


98 Expedition running rough you replaced the plugs wires and it ran smoothly for a while but missing again Does anybody know where you should look next Coils?

distributor cap and rotor


Why 1988 Toyota Camry will not start it cranks but no fire comes out of distributor it was running great until you change the battery you feel like you knock something loose or blown a fuse?

check to see if battery is connected correctly. and correctly is positive cable to positive terminal


How do you correctly spell quickly running?

Quickly running?


1989 Honda accord stopped running while driving and hasn't started since i replaced coil and distributor what next?

Diagnosis: Engine Won't Start or RunCheck related link below


How do you set the timing on a 1994 Pontiac sunbird 3.1 6cyc?

You don't. It has no distributor. The only thing to make sure of is that the timing chain is installed correctly....(if you've removed it) and that the plug wires are routed correctly. If it's running poorly you'll have to look at other reasons besides the timing.


Which way does the distributor turn on 350?

if you're looking down at the distributor it rotates clockwise while running.


1987 suburban stopped running now has no spark replaced coil cap rotor electronic ignition module in distributor?

I'm not sure I understand your question. The ignition module is suspect in this case and yes, it's under the distributor cap. You may also want to replace the distributor cap and rotor while your at it, they're cheap parts and hair-line cracks in a distributor cap can be hard to detect. If all of these fail I'd look at replacing the coil and coil wire to the distributor.


Distributor point settings 350 Chevrolet?

0.19 for brand-new points 0.16 gap for used points. The above answer may be adequate to get the engine running, but points are set correctly when you have a reading of 30 degrees on a dwell meter.


Where is the camshaft sensor on 1999 dodge dakota 3.9L?

It is inside the distributor, it has three wires running to it, and it looks like a small black plateIt is inside the distributor, it has three wires running to it, and it looks like a small black plate


1986 Chevy s-10 blazer and it has been stalling after approximatley 10 mins of running the starter rotor distributor cap spark plugselectronic control moduel been replaced any ideas?

Did you replace the fuel filter?