0
Isuzu Oasis
The Oasis was a minivan manufactured as result of an agreement between Honda and Isuzu from 1996 to 1999. It was offered in a front-engine, front-wheel drive layout and was the only minivan marketed by Isuzu.
9 Questions
How do you check the transmission fluid on a 1996 Isuzu Oasis?
To check the transmission fluid on a 1996 Isuzu Oasis, first ensure the vehicle is on a level surface and the engine is running at normal operating temperature. Locate the transmission dipstick, usually found near the back of the engine. Pull out the dipstick, wipe it clean, reinsert it fully, then remove it again to check the fluid level. The fluid should be within the marked range on the dipstick; if it's low, add the appropriate type of transmission fluid as specified in the owner's manual.
What is the spec for valve adjustment on 1996 Isuzu oasis?
For the 1996 Isuzu Oasis, the valve adjustment specifications for the 2.2L engine are typically set to 0.008 inches (0.20 mm) for the intake valves and 0.010 inches (0.25 mm) for the exhaust valves when the engine is cold. It's important to check the service manual for the specific model to confirm these measurements, as they can vary slightly based on production changes or engine variants. Regular adjustments help maintain engine performance and efficiency.
How do you add transmission fluid in 1997 Isuzu rodeo?
In my 93 Isuzu Rodeo you have to add your transmission fluid buy poring it into the the transmission fluid dipstick.
Where is the thermostat located on a 1998 Isuzu Oasis Honda Vtec engine?
The thermostat is inside of the top radiator hose inlet on top of the engine. The hose and the housing will have to be removed to access the housing.
If a 1996 Isuzu Oasis 22 does not have fire to the plugs after changing the timing belt, perhaps a spark plug wire got crossed when hooking up the spark plug wires. Check the coil to make sure the right firing order is being used. Check to make sure the distributor did not accidentally get turned when changing the distributor cap. Also, check the wires to the distributor.
Where is OBDII connector Isuzu Oasis?
I would visit the automotive car repair wiki, which has a database of OBD2 locations for all vehicles. In your case for a 98 its on the passenger side rather than the driver side like most vehicles. See photo below. http://www.fixexpert.com/obd2/data/honda/odyssey/1998.jpg If you wish to look up others OBDII port locations for other vehicles try the main link at: http://www.fixexpert.com/wiki/OBD-2+Location Good Luck.
Where is the dipstick for the transmission fluid on an Isuzu Trooper?
the trooper has no dipstick for trans its a sealed system on the trans pan you will find a fill plug and a drain plug the one on top inrecess is the one your looking for with the truck in park running remove fill plug fluid level should be just below that hole you can use ur finger to tell
How do you service Isuzu 4 stroke car petrol engine?
Remove the cam shaft, then you will hav access to the spark plugs, u can then change them. In terms of changing the oil, its a standard procedure, empty the oil tank frm the cap under the car, wait for it to drain completly, check the dipstick, if it reads empty, your all good!! Simply top it up with new oil and ur away :)
