Front Bumper need to come of ONLY
the bumper will have to be removed.
The front bumper on a 1984 Corvette is held on by several mounting screws, bolts, and clips. There are bolts which hold it to the steel frame under the bumper which need to be removed. The mounting screws will also need to be removed. Once all the hardware is off gently lower the bumper pulling off any left over clips.
To replace most front lightbulbs on 7 series, bumper has to be removed.
== ==
== ==
== ==
To replace the headlight assembly on on 03 Jetta, the grill and front bumper have to be removed before you can get to the screws below the lamp.
NO. Do not attempt to do so, as the bumper will be extremely unstable.
there is 3 10 or llmm nuts on the back of the headlight assembly, then once that is removed there will be 4 torx screws that hold the headlight trim in place, once these are removed then bumper fillers can be installed.
Bumper stickers can be removed from a car. At first the bumper sticker should be dried with a hair drier. After one minute it can be removed. The are underneath the bumper stickers can be cleaned with water.
Remove the luggage compartment rear trim panel. Have a helper hold the bumper while the bolts are removed. Remove the retaining nuts and slide the bumper off the set bolts. Installation is the reverse of removal.
how to replace rear bumper brackets on a 2002 Nissan sentra