The "OFF" message indicates that you have made 3 invalid attempts to enter your radio's security code.
Just leave the radio turned on in this condition for several hours. You should then see the "CODE" message. Now you can enter the code.
If your Volvo s40 radio is always off, you can turn it on using the power button. The button is on the left, top-hand side.
Leave the radio turned on in this condition for several hours. Then enter a proper security code for your radio. If you don't have the code, you will need to contact a Volvo dealer.
Leave the radio turned on in this condition for several hours. Then enter a proper security code for your radio. If you don't have the code, you will need to contact a Volvo dealer.
Turn the Radio Off was created on 1996-08-13.
I have an 1996 Audi Quattro A6 i changed my batteri and my radio went to safe mode. How do i get my radio off safe mode?
To unlock a 1995 Volvo 850 radio displaying "OFF," try turning the ignition on and then pressing the power button on the radio. If it remains off, hold down the "Seek" and "Tune" buttons simultaneously for about 10 seconds to reset it. If that doesn't work, you may need the radio's security code, which can typically be obtained from the owner's manual or a Volvo dealer. Once you have the code, enter it using the radio buttons to unlock and reactivate the unit.
I was told (just yesterday) by a Volvo dealership mechanic to leave the key in the on position for up to 2 hours. This applies to my 1994 940.
you turn the key on and off 25 times and the radio works as good as new.
To reset the radio in a 1994 Volvo 940, start by turning off the ignition and removing the key. Next, locate the radio's fuse in the fuse box and remove it for about 10 seconds before reinserting it. Alternatively, you can press and hold the "Power" button on the radio for about 10 seconds to reset it. After resetting, turn the ignition back on and check if the radio is functioning properly.
To remove the radio from a 1992 Volvo 240, first, disconnect the car battery to avoid any electrical issues. Then, use a flathead screwdriver to carefully pry off the trim panel surrounding the radio. Once the trim is removed, unscrew the mounting screws securing the radio in place, and gently pull the radio out of the dashboard. Finally, disconnect the wiring harness and antenna cable from the back of the radio.
*Turn off the radio press the 'set time' button while pressing the radio station buttons to set the time..
turn the radio off and press the set button use the seek button to adjust the time