0
On a 10-year-old York AC for a 3300 sq ft home the evaporator coil has a leak and upzone is not cooling should you repair or replace the unit and what is a typical price?
Wiki User
∙ 16y ago
Replace the entire system with a more efficient one. Current EPA guidelines call for a 13 SEER system. Cost will be approx 6500-8500 depending on geographical location, size of system, and current copper size. Disagree. The evap coil may need replacement. I don't know any AC mechs that repair them but if the leak can be found it is not a large problem. 5-6 hundred dollars either way. For the price quoted aove I think you can get a 16-18 seer replacement unit.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What are typical evaporator tubes made of?
Copper
Typical evaporator temperature in an air conditioning system is?
40-45 depending on load
What is a packaged HVAC?
Usually a package HVAC or Package unit is one large unit that has the evaporator and condenser in the same location unlike a typical system where the evaporator and condenser are located in separate locations. Package units are usually used for commercial building and placed on rooftops.
What is step 4 in a typical catering business flowchart - cooling cleaning preparation storage or cooking?
Cleaning
A typical induced draft furnace uses a blower off delay in cooling mode why?
increase the efficiency of the system
What is the rpm used by a CPU cooler system?
That would depend on a few things the type of cooling system and type of processor. Typical rpms of cooling systems can range from around 1300 rpm to 4500 rpm
Why does a radiator make a car work more effectively?
A radiator is a part of a typical cooling system that transfers heat away from the engine.
If relocating a home AC compressor-condenser unit how far from the evaporator can it be and could the condenser be remote from the compressor?
in a typical residential split system, the condenser fan is cooling the compressor so i wouldn't expect the same useful life from the compressor if it were not being cooled. you could set up its own fan i suppose. you can separate the evaporator and condenser about 25' (50' total line circuit) off the shelf. farther than that, the manufacturer usually has a larger line set (diameters) to keep the same performance rating. you also get into oil drainback issues, i.e. you have to pay attention in sloping the lineset to drain oil back to the compressor.
What is the typical energy balance for gasoline engine and for diesel engine?
for diesel: break power=34% cooling system=30% exhaust=26% surrounding=10% for diesel: break power=34% cooling system=30% exhaust=26% surrounding=10%
What is the typical cost to have a repair shop replace the water pump on a 97 Grand Am GT?
Depends on where you live. One suggestion is to replace all belts and coolant hoses at this time. You also want to have the cooling system flushed and fresh coolant added. The system will have to be drained and refilled when replacing a pump and doing all the other repairs at this time will save you money down the road. They need replacing anyway unless it has been done before.
Why car radiator is too hot after driving what is the cause?
Need to know what to hot is. A typical cooling system will run at 200 degrees F (+ or - 5 degrees). This is normal.
What is the average cost to replace a filter on a dehumidifier?
The HEPA filters cost considerably more.Around fifteen dollars is typical
