answersLogoWhite

0


Best Answer

This sounds more like a brake light switch than a bulb. The switch is mounted on a bracket right behind your brake petal.....an inexpensive replacement. If the lights work for a good long time after replacing both at the same time it could be a wiring issue that occurs intermittently. You should replace both brake light bulbs at the same time anyway.....safety first and all.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: On a 1995 jeep grand Cherokee limited must you automatically change both rear brake lights at the same time for both to work?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why are the lights flashing on my 1993 Jeep Grand Cherokee limited?

I had the same problem with my 1997 Grand Cherokee and it was the dash mounted automatic light switch. The problem was also solved by turning the headlamps on manually.


What causes Odometer and cruise lights ect. to quit working on 2003 jeep grand Cherokee limited?

I figured my own question out....all it was, was the fuse.


What model bulb would you use to gain the Blue color effect on a 2002 Jeep Grand Cherokee Limited?

sylvania silver star lights or actual hid lights will give you a blue look


Reset engine light after oil change 1996 jeep grand Cherokee limited?

Engine lights don't normally come on for an oil change. You have more of a problem. I'd suggest you take your Jeep to an Auto Parts store and have them run their OBC-tester on it and get a print out of everything that's wrong.


What would cause of the interior and exterior lights of a 1998 Grand Cherokee Limited to flash on and off and other times the interior lights will be on with it just setting in the driveway?

probably the heat on the drive ways or some cord in the car is just messed up.


The obstruction lights are turned on .?

automatically manually


Why do the low beam lights not work on my 1991 jeep Cherokee sport when all the other lights do including the high beams?

you have a bad headlight switch. easy to change out it's just a tiht fit under the dash


Why don't the brake lights and the tail lights work on your 2001 Jeep Grand Cherokee?

check your fuses


What are the wire color codes on the tail lights of a 05 Jeep Grand Cherokee?

What are the wire color codes on the tail lights of a 03 jeep grand Cherokee?Read more: What_are_the_wire_color_codes_on_the_tail_lights_of_a_03_jeep_grand_Cherokee.


Why don't my tail lights and dash lights work on my 1997 Grand Cherokee?

Check your fuse. Usually the manufacturer has the dash lights and the tail lights on the same circuit.


How much does it cost to replace low beam lights on a 2005 Jeep Cherokee?

The cost depends on where you take the Jeep Cherokee to be fixed. There will be a cost for the lights and other supplies plus a charge for the labor.


1995 jeep grand Cherokee limited entry lights stay on?

There is a dashboard illumination switch that controls the brightness. If it is pushed up fully, the interior lights will stay on. Lower the switch slightly until the interior lights go off. When doors are closed, if the switch is lowered, the lights should go off after about 30 seconds max, maybe less. Hope this Helps, it did on mine.