I have a 98 4dr trackertwo wheel dr. autotrans with a two part shaft with center support assembly consisting of cv joint and rubber vibration dampner with spline. This shaft is approx $1000.00 from dealer. Apparently instead of rebuilding, a straight shaft is offerd for a fraction of the cost. however I was told this may stress the drie train (trans/differintial?).or cause vibration posibly from engin harmonics? Check with Rockauto.com for shaft and have picture emailed. personally. Id rather spend $250.00 for a straight one and take my chances. I also need to ask myself why do they (CARDONE) make the stright shaft if it dozent work. Who do I ask if it does work> The shaft this guys mentions is a front shaft, not the 2 piece shaft that is required. They do not make a straight shaft. Junkyard or new is the only way to get what you need. For a 4dr 4x2 automatic.
how to replace wiper transmission assembly on a 2001 tracker
you need to buy bearings and bearing races most times they will come as a set you will also need axle seals and you will need bearing grease
You will need to remove the tire and wheel from your 2002 Geo Tracker. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.
You need to remove the transmission from the vehicle. Most people would take this to a repair shop.
how to replace the light bulb on the gear shift on 2004 tracker
Yes, kind of. HMS Tracker (D24) was an escort aircraft carrier of the American "Bogue" class. She served in the Royal Navy from 1943 to 1945.
how do I get to the front bearing on a geo 4 wheel drive
We can't do diagrams, sorry.
repair timing chain on 2000 chevy tracker
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
How do you change the front rotors on a 2004 Chevy tracker
no