one wire is power the other goes to the little cylinder thing beside it... its for reducing static or something... not important
look at the coil, it is marked - or +
there is a problem with your ignition coil or wires
im assuming your looking for hot wires on the coil. They should be two wires of the coil
You should hook up the wires for a tach on a 1985 Chevrolet s10 blazer to the negative side of the coil. You should be sure to identify the positive and negative sides of the coil.Ê
You should have C.O.P. ( coil on plug) there are no wires.
It has spark plugs, plug wires, and a distributor.
9 times out of 10 it is due to a bad coil. Where is your coil? Follow the spark plug wires until all of them come together. Auto parts store can check the coil for you.
Should be 9 larger wires (1 to each spark plug and 1 to the coil) Should also be a connector (small wire that leads to the negative side of the coil)
you can wireit directly to the coil... check for the positive and negative wires or there is also a place in your distributor.......
You need to find the red coil Wire under the hood of the car, And connect the positive side of the battery to the red coil wire. Then You need to then cross the starter wires located behind the steering wheel, The car should then start and the engine should be running.
A Chrysler Concorde does not use a distributor, so there is no coil wire.
There are no spark plug wires, this is a coil on plug system. The spark plugs are under the coils that bolt to the middle of the valve covers.There are no spark plug wires, this is a coil on plug system. The spark plugs are under the coils that bolt to the middle of the valve covers.