answersLogoWhite

0


Best Answer

This happened to me on my 806 and the answer was to remove the fuel tank, remove the fuel pump from the tank and remove any debris found in and around the pump suction - there is only a small inlet port on the pump so any debris eventually ends up there and blocks the suction for the pump.Since doing that I've not had the thing stop suddenly with little warning in the middle of the road! HTH

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Peugeot 806 hdi keeps cutting out and the engine management light comes onbut then the engine starts again when you turn the ignition on please help?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the engine management and ignition sensor on 2003 Nissan altima?

There are dozens of sensor that have to do with engine management and ignition all over the engine.There are dozens of sensor that have to do with engine management and ignition all over the engine.


What is the ignition timing on a Peugeot 206?

show me photo of timing engine peugeot 206 rc


Where is the engine management and ignition sensor on a 1999 Plymouth Neon?

Where is the engine management and ignition sensor on a 1999 plymouth voyager?


Where is the ignition module on a Peugeot 106?

The ignition module for a peugeot 106 is in the engine compartment. Facing the car with the hood open, the ECU is behind the headlamp nearest your left hand.


How do you install a duralast engine management and ignition in a 1990 gmc serria 1500?

where is a Duralast engine management and ignition part number SW2083 located


Engine turns over but will not start after fitting ignition barrel on peugeot 107?

six


How do you install a duralast engine management ignition in a 2003 Chevrolet suburban 1500?

can you sholme the diagram how to installl a duralast engine management ignition in a 20003 chevrolet suburban


What are the technical data of the engine and the maximum speed of the peugeot 305 GL 1978?

The technical data of the engine of the 1978 Peugeot 305 GL includes a spark ignition 4-stroke engine and 59 hp. Its maximum speed is 144 km/h.


Does a peugeot 406 2.0 hdi have a limp home fuction when engine management light comes on?

Yes it has.


Why does my peugeot 406 engine management system warning light keep turning on when i start the engine?

probley weak fuel pump or injectors.


How can you use the radio or CD player without running the engine on a 2007 Peugeot 307?

with the engine and ignition switched off .just press on/off switch on radio


Why is the engine management light flashing?

If the check engine light is flashing when the engine is running , that indicates that an ignition misfire has been detected