0
me to
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Is a Time Warner cable wireless router a wireless N router?
it says it on the router
What information is used by routers to forward packets?
The IP address. The router compares the destination IP address of an IP packet with the router's routing table, which says, for example, "everything that starts with 172.16.5 should be sent out through port Serial 2".
How do you open a port on your ip address?
It really depends on your router. But usually, you can open up Command prompt, type IpConfig, and then look for something that says Ipv4 address. Then go into your internet browser, type 192.168.0.1, find something that says "Port Forwarding" or "Port Opening". Then add a new one. Type a name for it, in the port spots, put the ports you want open, in the address spot, put your Ipv4 address. Bam. The port should be open.
Why do you not need to port-forward to allow remote access?
Many modern programs have a feature called NAT negotiation (or NAT traversal). Normally, if Client A wishes to establish a connection to Client B, but Client B has not initiated that connection then the firewall/router/NAT will not typically know what internal computer on the network to send the data to, port forwarding says 'If the NAT/Router recieves data on port X then direct it to computer Y on the network'. NAT negotiation allows Client B to tell his router 'If you recieve a connection on port X, then forward it to my computer'. It is similar to port-forwarding but it is automatic and only in effect while Client B has NAT negotiation turned on.
Can a wireless router plug into an Ethernet?
Yes, you can plug a wireless router in an ethernet. But don't forget to use the wireless router internet port when you are connecting to an ethernet. Should the question not be "Can an ethernet cable plug into a wireless router?". If so, then yes it can. Usually there are a few ethernet ports on the back of your router. One bit of advice I would give is to watch out for the internet port. I have seen people, plug a client computer into the internet port, even though it clearly says internet above it. Though some routers arent this helpful by labelling each port, so just be careful what port you do plug the ethernet into. Taking a different view of the question, I assumed you were asking if you could plug the wireless router into the wired network and use the same dsl or cable modem to get out. If that is the case, then the is still yes. But when you cable from your wired router to the wireless router, plug the cable in one of the (typically) 4 enet connections and NOT in the one marked Internet. Also, verify that you have the DHCP in the wireless router turned OFF, so addresses are assigned from the wired router. There can be 1, and only 1, DHCP server on a segment. (Only one boss for this job).
Why won't my wifi connect to my iPod Touch?
You may have high router security or an incompatible router. Some routers wont even let other devices see the network. So go to your router security and allow your device. Then on the iPod, go to settings hit wifi and where it says choose a network see of your network shows up and enter your password. If it doesn't show up, manually type in your ssid and security protocol then type you username and/or password and see if it connects. You can also try to set up the device through your router utility and a wifi protected setup (WPS) button on your router.
Why does my computer keep detecting my router then says a local connection area is unplugged?
This will often come up because the Router you are talking about would be a wireless router. The computer is sensing that an ethernet cable is not plugged in from the router to your computer. This will often come up because the Router you are talking about would be a wireless router. The computer is sensing that an ethernet cable is not plugged in from the router to your computer.
My DS says the Sky Router WEP key is wrong?
Are you sure the Sky Router is using WEP? The default is WPA, which a regular DS cannot decrypt.
What is the word mapping in math?
A mapping is a function.f: A -> BThis statement says f is a function and it maps from set A to set B.In order for f to be a function, for every element of A, there must exist uniquely f(a) in B.
What do you do in DragonVale if it says incompatible?
It simply means that the two dragons you selected cannot be bred together. Select a different pair.
What do you do when you try to connect your ds to your computer router but it says Nintendo ds does not support this type of router?
you might need a different kind of router. go to.. i think its just nintendo.com under the ds part and it should explain what kinds you can use
How do you open port 3074 for Xbox live it says it may be blocking it?
go to your firewall and open port 3074.
