Poulan 2025 fuel line routing diagram?

Show diagram of poulan chain saw fuel lines?

show diagram of poulan chain fuel lines

What is the routing for the fuel lines on a Poulan 3400 chainsaw?

Fairly simple. Fuel line up from tank.....underneath carb.....to right side of carb inlet fitting.

Where can you find a fuel line routing diagram for a 1976 Chevy 12 ton c-10 pickup truck?

A fuel line routing diagram for this vehicle can be found in the vehicles maintenance manual. It can also be found in the specific repair manual as well.

What is the fuel line routing on a poulan 2375?

The small line from the tank (with the fuel filter) goes to the top port of the carburetor. The large line from the fuel tank goes to the center port of the primer bulb. The other port of the primer bulb goes to the bottom port of the carburetor.

Where do you find a Vacuum hose routing diagram for 1984 Porsche 94?

www.clarks-garage.com go to the garage shop manual on the right side and under fuel and vacuum line routing www.clarks-garage.com go to the garage shop manual on the right side and under fuel and vacuum line routing

Need a full diagram for fuel line routing for a poulan 2150 chainsaw?

There are two lines inside the tank. The short line with no fuel filter on the end of it goes to the inlet, (suction) side of the primer bulb. The long line inside the tank, with the filter on the end goes directly to the fitting on the side of the carburetor. The line, inside the air box from the outlet side of the primer goes to the remaining fuel line fitting on the carburetor. http://store.chainsawr.com/

Fuel line routing 94 Camry?

The fuel routing on a 94 Toyota Camry runs from the fuel tank, along the frame, up the front of the engine, and into the fuel rail. The specific routing of the fuel line is important to prevent damage and ensure a steady flow.

Poulan chain Saw dies when full throttle?

You have a kink in your fuel line or you have debris in the carburetor.

Fuel line diagram for a 1994 camaro 3.4L?

I need the fuel pump diagram of the fuel lines to connect

Harley fuel lines diagram?

1999 Harley Davidson fuel line diagram

How do you replace poulan chainsaw fuel line?

I'm having the same problem with my Poulan chainsaw and weed eater. I think the line starts with the fuel filter in the tank and travels up to the primer bulb, out of the bulb into the carburetor, and out of the carburetor back to the tank. Whatever the size of line is that hooks to the fuel filter is what will hook to the primer bulb and then the carburetor. Then one more single line returns to the tank. I may not be correct on this, but there's not much information available. The diagram on Poulan's website does not show the routing of the fuel lines. that is right but to remove the main line you need to drain fuel and pull the line out from the fuel tank neck first because it has a connection that will not fit threw the hole in top. to replace it cut new line at a slaint and fir it threw from the top down into the fuel tank. then keep it long and pull out enough threw the fuel cap to put fitting back on it and fuel filter then pull it back threw and hook it to primer bubble. Not sure about your answer I have two different size fuel lines on mine. The larger line if I remember correctly runs from primer bulb to the right of fuel tank where the larger opening is located. The smaller line is where I am confused at shouldn't the smaller line from the fuel tank that has in tank filter attached run up to carburetor. then a smaller line from primer bulb to second fitting on carb. byrumjr the line starts with the fuel filter in the tank and travels up to the carburetor out of the carburetor into the primer bulb, out of the primer bulb back in the tank

What is the routing for fuel lines on a poulan 2375 chain saw?

It is not real clear, but the parts breakdown is linked below. To tell the logic of it, the line with the filter attached will go into the pump side of the carb (often the bottom) and the discharge will exit the mteering side. The pump side will have "flappers" and the metering side will have a metal disc.