0
Power seats in 1985 ford thunderbird quit working changed circuit for it and checked ground?
Wiki User
∙ 10y ago
When the power seats in a 1985 Ford Thunderbird quit working and the owner has changed the circuit for it and checked the ground, the cause may be the motor. The motor in the seat can be replaced by taking it to a mechanic who specializes in Ford vehicles.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Your brake lights and now the horn are out on your 1994 Volvo you changed the bulbs and checked the fuses and both seem fine all the rest of the electrical and lights are working do you think its elec?
If the brake lights & horn are on the same fused circuit the most likely cause of the problem is an open circuit before the fuse.
You have changed a headlamp bulb in your Vauxhall Corsa and it is still not working. The fuse has been changed as well.?
is the other headlamp working? if yes check for dirty contacts and damaged wires have you put the head lamp bulb in correctly have you checked the "faulty" to make sure that it is truly blown?
If one outlet on a circuit is not working will the entire circuit not work?
No
Why would your 1994 jeep wrangler check engine light come on at the same time that your speedometer stopped working?
Something in the speedo circuit has possibly failed and the computer set a code for it.. Have it checked for codes.
What happens if a wire breaks?
The circuit stops working because of the short circuit
Instrument panel not working 2002 F250 cranks but wont start?
changed cluster checked all fuses and they aer good no bad or broken wires going to o/d switch
Solidstate Servo Voltage Stabiliser working circuit diagram?
stabilizer circuit diagram
Will the printed circuit stop all gauges from working?
Depending which circuit burned out, yes.
What does a short circuit happen?
when the fuse is not working
Changed brake pads lights not working?
my lights are not working when i changed the pads on my peutgeo partner van
On a 1997 Daewoo Nubira the brake lights are not working but the central LED one is you have checked the fuses and changed the bulbs any ideas?
possible turn signal switch failure common on gm cars
If a circuit had a gap in it would it work?
Nope... if the circuit has a gap in it - the path of electrons is interrupted, and that would stop the circuit from working.
