Mixing a little bit will more than likely cause no problems other than poor performance until it is all gone. By little bit, I hope you mean less than a gallon. If you pumped more than that I would drain the tank.
yes, you can mix it 50/50 :) Not in a modern 'common rail' diesel engine - mixing could ruin it.
.Mixing a small amount of oil in the diesel fuel will not hurt a motor. The motor will run rough and produce black smoke.
Two stroke engines are lubricated by mixing special two-stroke oil in with the petrol.
It differs from a diesel engine in the method of mixing the fuel and air, and in the fact that it uses spark plugs to initiate the combustion process. In a diesel engine, only air is compressed (and therefore heated), and the fuel is injected into the now very hot air at the end of the compression stroke, and self-ignites. In a petrol engine, the fuel and air are usually pre-mixed before compression (although some modern petrol engines now utilise cylinder-direct petrol injection). The pre-mixing was formerly done in a carburetor, but now (except in the smallest engines) it is done by electronically-controlled fuel injection. Pre-mixing of fuel and air allows a petrol engine to run at a much higher speed than a diesel, but severely limits their compression, and thus efficiency
You may have a bad injector/s leaking diesel past your pistons and mixing with your crank case oil...... pull the dipstick and "sniff" it.... you will smell the diesel.
It will dramaticly reduce the fuels flashpoint causing the engine designed for diesel fuel to run hot and cause detination
Change your oil cooler.
You can do the shade by adding black little by little
Answer this question…Little mixing of ethnic groups took place throughout Central America's history because?
No is the simple answer... may help clean out your engine because of the detergent found in diesel oil ..just put the right oil in on your next service and change filter
by mixing the burn motor oil with grove heater the diesel will burn slower
Neither of those oils are indicated for these engines. OHV engines generally use 10W30 and L-head engines use 30W. Nothing prevents you from mixing weights, just check your oil level before starting.