answersLogoWhite

0

Don't proceed through a malfunctioning traffic signal without coming to a complete stop! Every states' laws say that a malfunctioning traffic signal must be treated as an "all-way stop" -- everyone must stop, and proceed in order of arrival.

User Avatar

Wiki User

18y ago

What else can I help you with?

Continue Learning about Law

A malfunctioning traffic signal should be treated like a four way stop?

Yes, treat a malfunctioning traffic signal as though it is a four-way stop by coming to a complete stop and taking turns proceeding through the intersection in the order that vehicles arrived. This procedure helps maintain safety and order at the intersection when the signal is not functioning properly.


A malfunctioning traffic signal should be treated like what?

Treat it like a four-way!-claudiaA traffic signal can fail in several different ways. Correct actions depend on the conditions you have carefullyobserved.First, a power failure of some form will cause a signal to become dark for all approaches, including pedestrians. If there is no other form of traffic control, such as a police officer or flagger, treat a dark signal as you would a stop sign. Avoid the dangerous mistake of assuming that others also understand this. Come to a full stop and when safe to do so, proceed with caution.Second if a signal is in a flashing mode your approach will be either flashing red or flashing yellow. Treat a flashing red as a stop sign as mentioned above. Do not assume the other approaches are flashing red also. It is possible other approaches are flashing red, yellow or dark. I have also observed situations in which one approach is in a steady red state while the remainder of the intersection is flashing red. The key here is to observe all that you can before making a move to enter the intersection. Flashing yellow is not so common any more, but if you are facing a this signal your actions should be to proceed with caution and yield to vehicles and pedestrians who may already be in the intersection. Be careful as drivers behind you expect to proceed on the flashing yellow too. Sudden stops or needless stops can result in your vehicle being rear-ended.Third, another type of commonly reported failure is that a signal is 'stuck' implying that one or more approaches are not receiving green service. There are two main reasons for this to occur. The first is that a sensor for your approach has failed to detect your vehicle. Observe other approaches to see if others are being served and that only your approach is being missed. That is the hallmark sign that a sensor is not working. Lanes that have a single lane, such as a left turn lane or some sidestreets generally have at least two sensors. One at the stop bar and one about 30 feet before the stop bar. It could take up to two vehicles to pull in behind you before the second sensor is tripped. If traffic is busy enough that should only take a minute to happen. On the other hand, if nobody else is coming, you may be tempted to go. If you have to go, remember to be safe and as obedient to the signal as possible. If you are in a left turn lane, it is safer to signal a right lane change and proceed on a green light with through traffic. If you are stuck at a red light in a through lane it is safer to turn right and go with the flow, or in the case of a one way street to your left, to turn left.If the signal is not cycling to any approaches other than the main road or street it is likely the signal is coordinating with other signals along a major route. Each signal along the route cycles according to its local demands, but those events are allowed only when the coordination releases the main route. The coordination can change at different times of the day. When it does, the cycle will tend to stay with the main route longer while the signal is getting back into step with the overall system of intersections. I have worked with systems that use coordination cycles that are up to three minutes long and longer while changing cycles. If you have been waiting for a long time for the signal to change and you feel that you need to leave right away, consider the safest and most legally defensible method for doing so. You will need strong justification for running a red light, especially if your actions cause an accident.There are many types of failures, but the key to safety is to be aware of the conditions and always prepared to stop or take evasive action.--mark


What was the traffic light law designed to do?

The traffic light law was designed to regulate and control the flow of vehicular and pedestrian traffic at intersections to improve safety and prevent accidents. It assigns right of way to different directions of traffic using colored lights to signal when to stop, proceed, or yield.


What is is violation code 22143 A given by a police officer?

Violation code 22143 A typically refers to disobeying a traffic control signal, such as running a red light or disobeying a stop sign. This means the driver failed to follow the instructions given by the traffic signal or sign, and may result in a traffic citation or ticket from the police officer.


Is a pedestrian jaywalking if they enter a crosswalk with the red countdown clock at 3 seconds?

If a pedestrian enters a crosswalk with a red countdown clock at 3 seconds, they are still considered to be jaywalking. Pedestrians should only enter a crosswalk when the signal is green or walk, not during the countdown phase. It is important to follow traffic signals for pedestrian safety.

Related Questions

A malfunctioning traffic signal should be treated like a four way stop?

Yes, treat a malfunctioning traffic signal as though it is a four-way stop by coming to a complete stop and taking turns proceeding through the intersection in the order that vehicles arrived. This procedure helps maintain safety and order at the intersection when the signal is not functioning properly.


What should you do if a traffic signal is red and an officer signals you to stop?

stop... A police officer assuming control of that intersection will have precedence over a traffic signal. If their signals are contrary to the traffic signal, you'll follow their signal.


When a traffic light malfunctions you should treat the malfunctioning light as a?

.... as a stop sign.


What traffic signal is used in heavy traffic intersections to tell people who are walking whether they should proceed or wait?

Pedestrian Signal


What should you do when you encounter a traffic signal with a flashing yellow arrow?

When you encounter a traffic signal with a flashing yellow arrow, you should proceed with caution and yield to oncoming traffic and pedestrians before making your turn.


What must you do when approaching a flashing yellow traffic signal?

When approaching a flashing yellow traffic signal, you should proceed with caution and be prepared to yield to oncoming traffic or pedestrians.


What does A traffic light with a flashing red signal means?

When you see flashing red lights at a 4-way stop Light instead of normal traffic signals you should approach the intersection as if it was a 4-way stop sign, alternating N/S and E/W lanes proceeding through the intersection, one car at a time. Typically this type of situation happens when the traffic signal system is malfunctioning.


What does a yellow arrow signal mean when displayed at a traffic intersection?

A yellow arrow signal at a traffic intersection means that the signal is about to change from green to red, and you should prepare to stop if you are able to do so safely.


What should a driver do when approaching a yellow traffic signal?

When approaching a yellow traffic signal, a driver should slow down and prepare to stop if it is safe to do so. If it is not safe to stop, the driver should proceed through the intersection with caution.


When does the airbag warning signal flash on the Hyundai Sonata dashboard?

The airbag warning signal might flash on the Hyundai Sonata dashboard if the component is malfunctioning. It should be checked by a mechanic.


Do you have to signal in Texas if not effecting traffic?

In any state you should signal within 100ft of turning but, to be safe you should always signal. Because you never know whats going to happen.


What does a red "x" traffic signal mean and how should drivers respond to it?

A red "X" traffic signal means that the lane is closed and drivers should not drive in that lane. Drivers should merge into an open lane and follow the instructions on any accompanying signs.