0
Don't proceed through a malfunctioning traffic signal without coming to a complete stop! Every states' laws say that a malfunctioning traffic signal must be treated as an "all-way stop" -- everyone must stop, and proceed in order of arrival.
Wiki User
∙ 16y ago
Wiki User
∙ 12y agoIf you encounter a malfunctioning traffic signal then you should treat signal like a 4 way stop sign. Whoever reached the intersection first has the right of way. If more than one person reached the intersection at the same time then the person on the right goes first.
Wiki User
∙ 12y agoYou should treat the broken stop light like a stop sign. Whoever reached the intersection first has the right-of way. If its a busy intersection then two cars will go at a time.
Wiki User
∙ 15y agoproceed with caution and go through and notify the police to fill in for the department of public works
Wiki User
∙ 15y agoYou take turns,like at a stop sign.
Wiki User
∙ 8y agoTreat it as a stop sign.
Add your answer:
Earn +20 pts
A malfunctioning traffic signal should be treated like a four way stop?
a malfunctioning traffic signal should be treated like?
A malfunctioning traffic signal should be treated like what?
Treat it like a four-way!-claudiaA traffic signal can fail in several different ways. Correct actions depend on the conditions you have carefullyobserved.First, a power failure of some form will cause a signal to become dark for all approaches, including pedestrians. If there is no other form of traffic control, such as a police officer or flagger, treat a dark signal as you would a stop sign. Avoid the dangerous mistake of assuming that others also understand this. Come to a full stop and when safe to do so, proceed with caution.Second if a signal is in a flashing mode your approach will be either flashing red or flashing yellow. Treat a flashing red as a stop sign as mentioned above. Do not assume the other approaches are flashing red also. It is possible other approaches are flashing red, yellow or dark. I have also observed situations in which one approach is in a steady red state while the remainder of the intersection is flashing red. The key here is to observe all that you can before making a move to enter the intersection. Flashing yellow is not so common any more, but if you are facing a this signal your actions should be to proceed with caution and yield to vehicles and pedestrians who may already be in the intersection. Be careful as drivers behind you expect to proceed on the flashing yellow too. Sudden stops or needless stops can result in your vehicle being rear-ended.Third, another type of commonly reported failure is that a signal is 'stuck' implying that one or more approaches are not receiving green service. There are two main reasons for this to occur. The first is that a sensor for your approach has failed to detect your vehicle. Observe other approaches to see if others are being served and that only your approach is being missed. That is the hallmark sign that a sensor is not working. Lanes that have a single lane, such as a left turn lane or some sidestreets generally have at least two sensors. One at the stop bar and one about 30 feet before the stop bar. It could take up to two vehicles to pull in behind you before the second sensor is tripped. If traffic is busy enough that should only take a minute to happen. On the other hand, if nobody else is coming, you may be tempted to go. If you have to go, remember to be safe and as obedient to the signal as possible. If you are in a left turn lane, it is safer to signal a right lane change and proceed on a green light with through traffic. If you are stuck at a red light in a through lane it is safer to turn right and go with the flow, or in the case of a one way street to your left, to turn left.If the signal is not cycling to any approaches other than the main road or street it is likely the signal is coordinating with other signals along a major route. Each signal along the route cycles according to its local demands, but those events are allowed only when the coordination releases the main route. The coordination can change at different times of the day. When it does, the cycle will tend to stay with the main route longer while the signal is getting back into step with the overall system of intersections. I have worked with systems that use coordination cycles that are up to three minutes long and longer while changing cycles. If you have been waiting for a long time for the signal to change and you feel that you need to leave right away, consider the safest and most legally defensible method for doing so. You will need strong justification for running a red light, especially if your actions cause an accident.There are many types of failures, but the key to safety is to be aware of the conditions and always prepared to stop or take evasive action.--mark
Is it legal in North Carolina to go under a red light after stopping if light won't change to green?
yes the law does say you have stay stopped just stop and the go if no other traffic is comingANS2:In the U.S., a flashing red light at an intersection is treated as a stop sign. Some states permit motorcyclists to treat a non-changing signal as a stop sign if the pavement sensor does not detect them. At an intersection with a malfunctioning signal, the intersection is treated as a 4-way stop. For other situations, if you are certain that you can convince the police officer who stops you for running the red light that you waited a reasonable length of time and you didn't interfere with opposing traffic, the officer might not cite you. The law says that you don't enter the intersection on red unless directed by police.
What was the traffic light law designed to do?
traffic lights were designed to control the traffic flow in largely populated areas.
How long does a traffic misdemeanor Failure To Appear stay on your record?
Failure to appear for a traffic offense is not a new charge. It does appear on your driving history because it normally suspends your driver's license. However, as soon as you appear and have the underlying offense resolved, the FTA should be cleared from your record.
A malfunctioning traffic signal should be treated like a four way stop?
a malfunctioning traffic signal should be treated like?
When a traffic light malfunctions you should treat the malfunctioning light as a?
.... as a stop sign.
What should you do if a traffic signal is red and an officer signals you to stop?
stop... A police officer assuming control of that intersection will have precedence over a traffic signal. If their signals are contrary to the traffic signal, you'll follow their signal.
What traffic signal is used in heavy traffic intersections to tell people who are walking whether they should proceed or wait?
Pedestrian Signal
What does A traffic light with a flashing red signal means?
When you see flashing red lights at a 4-way stop Light instead of normal traffic signals you should approach the intersection as if it was a 4-way stop sign, alternating N/S and E/W lanes proceeding through the intersection, one car at a time. Typically this type of situation happens when the traffic signal system is malfunctioning.
When does the airbag warning signal flash on the Hyundai Sonata dashboard?
The airbag warning signal might flash on the Hyundai Sonata dashboard if the component is malfunctioning. It should be checked by a mechanic.
Do you have to signal in Texas if not effecting traffic?
In any state you should signal within 100ft of turning but, to be safe you should always signal. Because you never know whats going to happen.
Other name of traffic signal?
Stop light is another name for a traffic signal.
When a traffic light is turned off what should you do?
You should treat it as a stop sign. If there is a power outage or malfunctioning light, come to a complete stop at the intersection and yield to cars that stopped before you did.
Traffic left justified junctional last when should you signal?
Left-Turn Signals: Where left-turning traffic is especially heavy and/or the amount of.
A traffic sign which is used to control traffic is called a what?
traffic signal.
What is an inoperative traffic signal?
A signal light that is not working.
