KEYLESS ENTRY SYSTEM With the keyless entry keypad, you can: • lock or unlock the vehicle doors without using the key. Your vehicle has a factory set 5 digit code that operates the keyless entry system. You can also program your own 5 digit personal entry code. The factory-set code is located: • on the owner's wallet card in the glove compartment • or at your dealer. When pressing the controls on the keyless entry keypad, press the middle of the controls to ensure a good activation. This system will disable the power door lock controls. These will not work until the vehicle is disarmed. Programming your own personal entry code To program your own code: 5. Enter factory set code (keypad will illuminate when pressed). 6. Press 1/2 control within five seconds of step 1. 7. Enter your personal 5 digit code. Enter each digit within five seconds of previous one. 8. After the code is entered, the locks will cycle, confirming that the new code has been set. Do not set a code that includes five of the same number or presents them in sequential order. Thieves can easily figure out these types of codes. Your personal code does not replace the permanent code that the dealership gave you. You can use either code to unlock your vehicle. If a second personal code is entered, the module will erase the first personal code in favor of the new code. Locks and Security 149 Locks and Security If you wish to erase your personal code, use the following instructions: 1. Enter factory set code. 2. Press 1/2 control and release. The system will now only respond to the factory set code. Anti-scan featureThe anti-scan feature prevents repeated attempts at arriving at a valid key code. The keyless entry pad is disabled for 1 minute after 7 unsuccessful attempts (35 consecutive button presses) at entering a valid key code. The keypad will flash during this 1 minute mode. However, the 7/8 and 9/0 controls will still lock the vehicle. Anti-scan will be turned off after: • one minute of keypad inactivity. • the remote entry transmitter UNLOCK button is pressed. • the ignition is turned to the ON position. Unlocking the doors with the keyless entry system To unlock the driver door, enter either the factory set code or the personal code (each digit must be pressed within five seconds of the prior digit). The interior lamps will also illuminate. To unlock all doors, enter the factory set code or personal code (driver door unlocks) and press the 3/4 control within five seconds. Locking the doors with the keyless entry system It is not necessary to enter the factory or personal code prior to locking all doors. To lock the doors: • with the driver's door closed, press the 7/8 control and the 9/0 control at the same time. Locks and Security 150
5W-30 ( according to the 1998 Lincoln Navigator Owner Guide )
On a 1998 Lincoln Navigator : The thread on cap on the engine coolant reservoir is the pressure cap / radiator cap
According to the 1998 Lincoln Navigator Owner Guide : ( " regular " unleaded , 87 octane gasoline is used )
On a 1998 Lincoln Navigator : The ELECTRIC fuel pump is INSIDE the fuel tank ( it goes in from the top side of the tank )
On a 1998 Lincoln Navigator I believe it is in the front passenger footwell ( it might be behind an access panel )
You can view the 1998 Lincoln Navigator Owner Guide online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides
6x9's
According to the 1998 Lincoln Navigator Owner Guide : ( 5W-30 , 6.0 U.S. quarts with engine oil filter change )
According to the 1998 Lincoln Navigator Owner Guide : With engine oil filter change : ( 6.0 U.S. quarts )
According to the 1998 Lincoln Navigator Owner Guide : ( 30 U.S. gallons )
According to the 1998 Lincoln Navigator Owner Guide : ( " regular " unleaded gasoline , 87 octane )
because you own it