Push on joints seal by the spigot end expanding (and thus compressing) the rubber gasket in the bell. A Mechanical joint compresses the gasket in the bell by pressing a gland follower against the gasket, by tightening bolts. They both achieve good seals when done according to makers instructions, but MJ joints are more work, and have bolts that can corrode and freeze. If there is an advantage to,MJ joints I have been unable to find it. Note: MJ joints do NOT prevent pipe pull-out. The pipe must be restrained somehow, just as with push-on. David Philips PE
Black of course
Pipe organ has the most harmonics.
The first difference is actually pipe vs tubing. Pipe is measured at the inside diameter or ID vs tubing being measured at the outside diameter or OD. Dies for bending pipe and tubing are different because of the different measurements. A mandrel is pulled through tubing or pipe to keep the inner diameter constant.
i raced my friend on my 07 400ex and i smoked his 06 300ex and he had his HMF slipe on pipe to.
One example is the painting "The Treachery of Images" by RenΓ© Magritte, which depicts a pipe with the words "Ceci n'est pas une pipe" (This is not a pipe) underneath. This challenges the viewer to question the relationship between an object's appearance and its reality.
API X70 is one of line pipe grade family define by API 5L specification
Faucet supplies are 1/2" NPS vs. pipe 1/2" IPS. they are 2 different threads.
If the flow velocity remains the same the flow volume will increase by the square of the diameter ratio.(2/1.25) = 1.6 = diameter ratio1.62 = 2.56 more flow volume through 2 inch pipe compared to 1.25 inch pipe.
The 250R is going to win
Pipes & tubes have the same purpose for fluid transfer, however Pip is measured in terms of its Internal diameter (I.D) whereas tubes are measured in terms of its Outside Diameter O.D e.g An 1 1/4 " Pipe will have 1.25" ID + Pipe thickness A 1 1/4" Tube will be its actual OD i.e 1.25
While metals can be maliable, it is more often a non-metal. Think dirt vs. a lead pipe.
The more air that moves on the final stroke of a combustion cycle, the better the performance. If the single pipe from the engine is large enough, then yes, it can outperform an engine with a true dual exhaust with smaller pipes.