Ford Windstar
Ford Explorer
Ford Ranger
Ford Windstar SE

Radiator flush Ford Ranger 1997?

212223

Top Answer
User Avatar
Wiki User
Answered
2006-10-17 22:56:32
2006-10-17 22:56:32

The radiator drain is located under the radiator (you may have to raise your vehicle to spot it beyond the shield). (1)Remove radiator cap and attach a 3/8" diameter hose to the drain fitting to direct the coolant into a container and then open the drain fitting with a pair of pliers. (2)Flush radiator with fresh water from a garden hose until water runs clear through the plug. (3)Refill with 50/50 mixture of water and antifreeze. Piece of cake, huh!! The hardest part is locating the drain fitting which appears to be well hidden, but I think it is on the driver's side of the radiator. Good luck. By the way, intructions are from Haynes Repair Manual Ford Ranger 1993 - 2005.

012
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Buy a flush kit at Wal-Mart or auto parts comes with fittings adaptors and instructions

Buy a flush kit at Wal-Mart or auto parts- comes with instructions fittings and adaptors

Flushing is best done at an oil change service center. ask your local service if they do it, or look in the phone book.

The 1997 Ford Ranger engines are fuel injected , so no carburetor

what type of radiator fluid does a 2000 ford ranger take?

Drain the radiator. Leaving the drain plug open, run water from a hose into the radiator and continue to flush until the out coming water is clear.

On a 2000 Ford Ranger : With the engine cold the radiator should be filled to the seat for the radiator cap and the engine coolant reservoir should be filled to the cold mark

Will a 1997 Aerostar transmission fit in a 2000 ford ranger?

It's supposed to be in the engine compartment , in front of the radiator , at the top , held in place by 2 clips

At the bottom of the radiator, you can see it from under the truck.

ANSWER: On the lower left side of the Radiator (passenger side).

( 5W-30 ) is the preferred oil , according to the 1997 Ford Ranger Owner Guide

The diagrams of the different systems in a 1997 Ford Ranger can be found in a Ranger service manual. The manual is available for purchase in most auto parts.

No , the 2.3 liter 4 cylinder engine in a 1997 Ford Ranger is not an interference engine

looking at the motor, its on the right side of the radiator at the bottom

Does not have one. Just a reservoir.

what should i use to fix a small crack on top of radiator. on a 1998 ford ranger what should i use to fix a small crack on top of radiator. on a 1998 ford ranger

The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.

I need a picture diagram for a 1997 Ford Ranger engine so I can locate where the thermostat is? Please help!!!

The 1997 Ford Ranger ECM computer is located behind the dashboard. The computer will be on the passenger side of the passenger compartment.

A little more information please Size of engine , with or without air conditioning in your 1997 Ford Ranger

follow the top radiator hose to the motor the hose is clamped to the thermostat housing remove the housing and you will find your thermostat


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.