The Evaporator is the part of a refrigeration system that absorbs heat. Its counterpart is the condenser which is used to remove heat that was absorbed in the evaporator.
Metering device
cause its a gas
Liquid receivers are used to store the liquid refrigerant after it leaves the condenser. It should be located below the condenser to enable natural flow. The receiver may be constructed either vertically or horizontally and should have sufficient capacity to hold the entire system's refrigerant charge. The design should be such that only liquid refrigerant leaves the receiver and enters the liquid line. by vishal mahnn
the boiling point of refrigerant in a refrigeration or air conditioning system determines the pressure of the low side of the system
The Evaporator is the part of a refrigeration system that absorbs heat. Its counterpart is the condenser which is used to remove heat that was absorbed in the evaporator.
It is fitted on discharge line after condenser, where the gas enters in liquid forms.
Metering device
In vapour compressor refrigeration system the low pressure and temperature vapour refrigerant from evaporator is compressed. where it is compressed to a high pressure and temperature. From compressor refrigerant goes to condenser where where it changes the phase. from condenser refrigerant goes to evaporator through expansion device.
The condenser is a coil in a refrigeration system. It is on the low pressure side and is exposed to ambient air temp. The refrigerant goes through that and is cooled off and is then sent to the compressor.
15
Pancake Coils are often used as evaporator and condenser coils in refrigeration systems.
Compressor, Condenser, Meter Device and Evaporator
pressure in a refrigeration system is changed in the
Vapor compression in the refrigeration cycle is the process which turns heated vapor into a cold liquid. This allows the coolant to flow through the condenser and cool the air.
A package unit contains all elements of the refrigeration cycle in one system. The 4 major components include: A compressor, condenser, metering device, and a evaporator. All elements are needed to complete the cycle of refrigeration. As for a split unit, All elements of the refrigeration cycle are used, however the condenser is located outside of the facility, while the evaporator is located inside of the facility. To better understand the difference in question, you must understand the job of each component in the refrigeration cycle. For example, a condenser is normally used to reject heat or cold air from a building, while a evaporator normally supplies heat or cold air to the building.
There are several roles of a condenser system depending on what is using it. In a microscope, a condenser system helps gather and focus light for a clearer view. In an air conditioner a condenser system cools heated gas so it can be used again.