Vapor compression in the refrigeration cycle is the process which turns heated vapor into a cold liquid. This allows the coolant to flow through the condenser and cool the air.
Compressor
Condenser
Expansion Valve
Evaporator
the Carnot cycle has 2 constant specific volume processes (heat in & heat out) the air refrigeration cycle is based on a brayton cycle which has two constant pressure processes.
Pressure increases due to load(or heat intake from evaps).if asking about off cycle. If asking about compression cycle,its the compression of vapor into a higher pressure side of system along with heat of compression adding to temp-pressure relationship.
COP will be the quocient between what you want over what you payed for that is: QC / WC Or for a reversible carnot cycle since WC = QH-QC QC / (QH-QC) or TC / (TH - TC) Where TC - Temperature of the cold reservoir TH - Temperature of the hot reservoir WC - Work of compression QH - Heat given to the hot reservoir QC - Heat taken from the cold reservoir
the reversing valve is what actually changes the refrigeration cycle from heat to cool. the reversing valve receives its signal from the thermostat.
carnot cycle?
suction filter
In practical applications, vapor-compression refrigeration systems are the most commonly used refrigeration systems, and each system employs a compressor. In a basic vapor compression refrigeration cycle as shown in Figure 3.28, four major thermal processes take place as follows: • evaporation, • compression, • condensation, and • expansion.
To really understand how air conditioner removes heat? You have to know thermodynamics second law: " heat always flows from a material at a high temperature to a material at a low temperature." There're so much to it! AC condenser unit is the components that removes the heat in air conditioner. You also have to understand the other AC four basic components to know how and why it removes heat. Read: Basic refrigeration cycle and refrigeration cycle how air conditioner works refrigeration theory Youtube video on Principles of refrigeration video Good Lucks!
First step in refrigeration is evaporation. The next step is compression, which raises the pressure of the refrigerant vapor. Condensing is the third step and is where the heat transfer takes place. Expansion is the fourth step and is where the condenser cools the refrigerant even more, to a level below the condensing temperature.
The Bell-Coleman Cycle is also known as the Air-Standard Refrigeration Cycle or Reverse Brayton Cycle. This 4-process refrigeration cycle involves isentropic compression, followed by isobarric heat rejection, then isentropic expansion (usually by a turboexpander), and finally isobarric heat intake.This cycle is commonly used in jet aircraft, using engine bleed air for compression and venting to the atmosphere. It is also commonly used in commercial air liquification plants.
Brian Mongey has written: 'The experimental evaluation of a ternary mixture as an alternative to R22 in the vapour compression refrigeration cycle'
what are the six states of a refrigerant in a refrigeration cycle
The Carnot cycle is an idealized thermodynamic cycle that describes a perfect heat engine. In the Refrigeration system we need cooling effect.so it has to operate in opposite nature to produce the cooling effect. So we run the catnot cycle reversly in the refrigeration system. So we call the Refrigeration cycle called as REVERSED CARNOT CYCLE.
Your freezer operates on the basic principles of the refrigeration cycle. Your freezer does not make cold, it removes heat from the cabinet space. That heat is then discharged to the outside of the unit via a set of coils (either on the back or bottom of the unit). This cycle should keep the operating components of your freezer operating well throughout the winter months.
at compressor
First step in refrigeration is evaporation. The next step is compression, which raises the pressure of the refrigerant vapor. Condensing is the third step and is where the heat transfer takes place. Expansion is the fourth step and is where the condenser cools the refrigerant even more, to a level below the condensing temperature.
are you asking how to use your cars a/c system to chill the intake air temp please specify what you want to do