first remove the wheel. next remove the hub nut in the middle of the rotor. it will be bent to keep it from twisting loose so you will first have to straighten the bend. next remove the nut. once that is all done install a flange on a slide hammer and bolt it to the rotor where the wheel is normally bolted to it. using the slide hammer will free the rotor from the spindle exposing the bearings
you have to take all brakes and rotor off the hub. then you must spin the hub so the access hole is in front of the bolts,and take all 3 bolts off. then you must pull the hub off of the spline.
The stock speakers in a Festiva are 4 inch all around
To install Ford Festiva front wheel bearing, the engine must be stopped and the car taken to a flat surface. The jack is usually used to lift the vehicle.
In fact it' a 1993 festiva standard. How put off old plates on front discs braques?tancks!Constant
a jack shaft is the small drive shaft from transfer case to front differential, brakes have nuthing to do with removal of a jack shaft maybe you mean removal of front axle
send it to a mechanic
Front Line Assembly was created in 1986.
AnswerVery easy. One screw on the top of the assembly and one on the front. Disconnect the wiring connectors and pull the assembly out. Installation is the reverse of removal - be sure to line up the tab on the bottom of the assembly with the hole in the frame. It's actually quicker to replace the whole assembly than just the bulb....
Passenger lower front fender /w horn relay front end driver side
Its under the right front fender, behind the bumper(passenger side)
this is a slightly vague question, but i will try to answer. check the front brakes. check the hubbearing. check cv axle, make sure axle nut is not loose.
Queen Victoria's statue is in front of the House of Assembly.