0
What else can I help you with?
What is the firing order of 1992 Nissan Pathfiner?
123456
What type of motor oil in a 1992 Nissan Pathfiner?
What type of motor oil in a 1992 Nissan pathfinder?Read more: What_type_of_motor_oil_in_a_1992_Nissan_pathfinder
How do you replace driver side exterior door handle to a 1992 Nissan Pathfiner?
W/ a new one
How do you remove the window crank on a 1992 Toyota Paseo?
To remove the window crank on the 1992 Toyota Paseo, first pry off the interior door panel. Then, access the screw that holds the crank in place. Remove the screw and the handle will come loose.
How do you remove the door panel on a 1992 Nissan truck?
remove the door handle and window crank (you can use a coat hanger to remove the clip) remove the door lock knob. Then reach down at the bottom and pull out the panel. Install in the same order.
If you slip the timing belt on a 1992 v6 Nissan Pathfiner will it bend valves?
it won't slip, it will break if anything, and yes it will bend the valves
How do you remove the tourqe converter bolts from a 1992 Nissan Pathfiner?
After you have removed the cover from the lower half of the torque converter housing and driveplate you can remove the four bolts that secure the torque converter to the driveplate. Remove them one at a time by rotating the engine so that each bolt comes into view at the bottom where you have removed the driveplate cover.
Where is the water pump weep hole on a 1992 3.0 Nissan Pathfiner?
On top of the water pump just behind the pully. It is all located behind the timing belt.
Where is the key code in a 1992 Nissan Pathfiner?
In a 1992 Nissan Pathfinder, the key code can typically be found on a label inside the vehicle. Check the driver's side door jamb or the glove compartment for a sticker that might have the key code printed on it. If the code is not there, you may need to contact a Nissan dealership with your vehicle's VIN for assistance in retrieving the key code.
Where is the crank position sensor located on a 1992 Nissan maxima?
On a 1992 Nissan Maxima, the crank position sensor is typically located near the engine's crankshaft, often mounted on the engine block or timing cover. Specifically, it can usually be found towards the bottom of the engine, near the transmission bell housing. You may need to remove some components for better access, depending on the specific engine configuration. Always refer to a repair manual for detailed instructions and diagrams.
Where are the freeze plugs in a 1992 Nissan Pathfiner?
In a 1992 Nissan Pathfinder, the freeze plugs, also known as core plugs, are typically located on the engine block, often on the sides and rear. They serve to prevent coolant from freezing and causing damage to the engine. There may also be additional freeze plugs located in the cylinder head. To access them, you'll often need to remove components such as the intake manifold or exhaust manifold, depending on their location.
How do you replace brake pads on a 1992 Nissan Stanza?
You will need to remove the tire and wheel from your 1992 Nissan Stanza. Remove the brake pad spring and caliper. The brake assembly will come off. Reverse the process to install the new brake pads.
